Tofty's Custom Brass Torches
-
Some of you may have caught some of this plan on another thread:
/topic/31876
but since finishing this project is going to take a while i felt it could do with its own page.This is a shell mod for a cheap Chinese AAA LED torch, with a few added features like a lanyard point and improved water resistance.
This is the first of three sections completed:

Do stay tuned.....
-
that looks great mate. i fink it looks nice in half black half brass.

-
Oh, I'm tuning into this thread for sure. Looks lovely mate.

-
Splendid job, look forward to seeing it finished

-
Looks like it will be an interesting project.
And pics are always welcome here, and lots of them. I for one would like to see the process of making one too. 
-

Looking great!!

-
That's a nice one.

-
I really need to figure out how to use my knurling tool properly. Any tips Toft?.
-
Thanks everyone,
Funny you should ask Eric, for some reason my knurler has just stopped working for me, don't know why.
Normally it works first time but i had to turn this torch part down to about 15.7mm diameter (from 16mm) before the knurling aligned properly and since then i cant get it to work at all. I'm going to go back to some theory study and then experiment over this weekend. As requested the making of the next section will be accompanied by a 'process of making' photo guide so i'll make a point of showing the knurling setup and any conclusions i come to on the matter........One thought i have had but not tested is that the surface has to be very smooth or the wheels tend to wander between cutting lines causing the knurling to skip, the parts that have failed haven't had a smooth surface as i meant to sand them down after knurling. -
Some slightly better shots of the first piece:


I'm starting the think that i may not knurl the middle and back parts anymore, we shall see......
-
Polished brass looks great too!! :D
-
Tease.....

Still a fair amount to be done but it's nice to know the internal dimensions are right and good contact is being made on the light engine board, a quarter turn of the head turns it off and with an extra o-ring the action is a little firmer than the original.
As you can see i've knurled the full length, i'll go into detail with some pictures when everythings finished, the main thing still to do is cut some flats into the main body for the pocket clip to rest on and de-burr the end cap after having milled it's lanyard hole.
-
Its Alive!!! :ahhh
Very nice

-
Very nice work. I did warn you about modding torches, there's no turning back now :ahhh
-
Ok when will you be selling these??????
-
There's no gain in trying to sell torches like this one as the internals are still those of a £2.50 torch and it just doesn't justify itself, i made this as an experiment into various techniques and quickly realised the man-hours involved are too great, i mean i still haven't actually finished it yet (awaiting a special milling bit).
I suspect the only chance of there being a small brass torch for the people is to petition maratac into making them. I'm not sure if the copper torches were considered a success or not by them so they may think it's a terrble idea to make another speSmurfpillst item anway.
-
Finally finished:





I'll put up pictures showing some of the biuld process tomorrow.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login