Help! 58mm back spring setting
-
Put the two springs on, they fit easily.
Put the tool on top then use long nose pliers to squeeze the free end of the spring back against the captive end of the other spring. The tool should just about drop into place on its own.
Do same for the opposite tool in the layer. Add liner.Rinse and repeat.
-
Like ptrsak said but add the liner before pushing the springs in. I use a small screwdriver to push them in. If not you may bend the pivots and have to start all over again.
-
I'm not sure if you're questioning the initial spring setting or setting the tools in place. PTRSAK addressed the tool setting, so I'll give a quick rundown on setting the springs initially. If you look in the modding sticky thread, I've got a 58mm mod thread that shows pics of the process.
If you're looking at the knife left to right (two pins on the left, two on the right), take a spring and install it on the far pin opposite of where you want the tool to live; make sure the end goes between the pins on the opposing side. Just let it drop into place. Don't try to put on the tool yet. Make sure the springs' bellies face inward toward the center of the knife so that they can counter one another. Now, install the near spring on the pin diagonally opposite of the first one (e.g., if the first spring pivot is on the top right, this spring should be bottom left). To set it, pull the belly of the spring back toward you with your fingers and apply some slight downward pressure. It'll pop down into place and you'll be good to go.
-
The only problem I usually have is the first layer, once you get one layer together and a liner on the others are less trouble. I often put some low tack tape over the bottom bits to hold them in place and pull it just as I push the liner down. There's alot of force on those little springs and its annoying when they come apart JUST as you have the liner on.
-
I'll add one to that. It's extremely annoying when a preceding layer pops a spring after two more are already assembled on top of it.
-
make a jig.
-
I broke down a couple of classics, a bijou and a rover the other day with the aim of making a rogue. 4 different types of spring from each. I assume it won't matter if I mix and match springs of different sorts, as long as I keep opposite pairs together in the same tool layer.
-
@TazzieRob said:
I broke down a couple of classics, a bijou and a rover the other day with the aim of making a rogue. 4 different types of spring from each. I assume it won't matter if I mix and match springs of different sorts, as long as I keep opposite pairs together in the same tool layer.Shouldn't matter as you said. Keep like parts together
-
Ya the springs work fine if paired the same. I have many many spare new style ones if you need any.
-
@Syph007 said:
Ya the springs work fine if paired the same. I have many many spare new style ones if you need any.Awesome, mate, thanks for the offer. I'll know where to go if I get stuck. Will try with what I have first. Still need to get some pin stock. Have a mate into model building who may have something the right size
-
1/16" pin stock is the stuff for it. I don't know about the UK, but pretty much every hobby store I've ever seen in the US has it.
-
1.6mm in the metric system
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login