Awl Sharpening Question
-
Hey guys - The awl on one of my older Electricians has a couple dings on the edge, and the edge itself pretty dull.
Before I attack it with a stone, and possibly screw it up, been known to happen, I was wondering if I could get a little input from a few others who may have touched up the awl.
On occasion, the awl does come in handy when I need to poke a hole, or something like that. I've even used it to open up boxes in the mail.
Thanks! Joe

-
I use the awl quite a bit and sharpened it a few times already. My prefered method is to put sand paper on my strop and sharpen it like a chisel. Grit is related to the dullness of the awl of course but in general 400-600 would work best.
-
The awl is one of my favorite tools on SAK's.I use it as a chisel edge cutting tool for plastic zip ties and stuff I know is going to mess up my primary edge on my pioneer. It's ground in a chisel edge, so it's very easy to touch up. JUst use a dry erase marker to color the side you will sharpen it make sure you duplicate the factory bevel. Then use a fine diamond hone to take a few swipes then check to see it your at the right angle. You just need to hone the one side.

-
Ah, good call. Didn't think of using a marker on the edge. I was wondering about keeping the proper angle.

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login