Replace phillips head on Evogrip 18?
-
What would you like to replace it with?
-
I'd like to replace it with a smaller phillips head because most of the screws i use this for are smaller than this one can fit in
-
It sounds like a job for the integrated 1/4" drive replacement. Where is that post?
-
Could you link that post here please
-
I'm having problems finding it. I'm not sure if I bookmarked the post. Even when I do (bookmark them), I still have a problem finding threads that aren't well labelled. I'll keep looking for it. Someone was working on taking a 1/4" drive adapter and hand filing it down to fit in in place of the Phillips / Corkscrew on the backside of a Victorinox.
-
I finally found the thread. I wish threads would have better names. "Mod thwarted...by steel. Dang its strong properties!!!" is not very descriptive when you are searching for; hex bit, backside, adapter, corkscrew or phillips mod.
</topic/51745
The idea is still physically "big" (it takes up more room on your knife), but you can use different adapted tools with it. (Small phillips, large phillips, whatever.)
-
Thanks Kosmo
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login