Alox pivots
-
As far as i can tell, Knifekits are the only option. You might be able to get someone in the US to forward some on for you but postage will still be pricey.
-
Ok mate thanks very much, are there any modders in the UK doing alox stuff?
-
I do a bit - sporadically and very slowly :-[ . There must be others but not on here I don't think.
-
Usaknifemaker is much cheaper shipping for international. I get screws from there but they also have pivots. I think shipping was $6 for tiny parts like screws.
http://usaknifemaker.com/pivot-barrel-1-8-x-5-for-folders.html
-
Good tip, thanks! Looks like about $15 minimum shipping to the UK.
-
Thanks for your input guys, I have trouble believing that the barrels and screws 'exist' in the UK, but whether they are sold as knife parts...maybe not. SpeSmurfpillst electric parts maybe? The only thing is that the knifekits etc ones are hardened.
-
I have put some feelers out with a few different companies that deal with precision stainless tubing etc, and small screws. The tubing might need to be tapped but as it is sold in lengths, it can be cut to size.
Hopefully we can get some options for UK members. -
@zimchaz said:
I have put some feelers out with a few different companies that deal with precision stainless tubing etc, and small screws. The tubing might need to be tapped but as it is sold in lengths, it can be cut to size.
Hopefully we can get some options for UK members.I share your frustration at the difficulty but we already pay through the nose for our MTs. Less sure about SAKs. I would say that the postage is not such a bad deal for the benefit of pre-engineered parts. Another member has talked about $300 to engineer and source parts from China.
Just buy a modest selection of hard to obtain parts. TBH tooling to drill out to 3mm is potentially more expensive.
-
I have put some feelers out with a few different companies that deal with precision stainless tubing etc, and small screws. The tubing might need to be tapped but as it is sold in lengths, it can be cut to size.
Hopefully we can get some options for UK members.I share your frustration at the difficulty but we already pay through the nose for our MTs. Less sure about SAKs. I would say that the postage is not such a bad deal for the benefit of pre-engineered parts. Another member has talked about $300 to engineer and source parts from China.
Just buy a modest selection of hard to obtain parts. TBH tooling to drill out to 3mm is potentially more expensive.
Yeah I have thought that the lathes and things needed for drilling out 3mm will be expensive, but I have other ideas[emoji12]
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login