KPT (Kampfer's Pocket Tool)
-
Not bad for a first draft.
The outward pointing screwdrivers are asking for trouble though, I'd make them parallel to the tool sides, but made one a tiny bit shorter than the other so they're not in a way. I feel 'pain' just by looking at them

That's however easier said than done, because the shorter screwdriver end will always "suffer" as the longer bit will be in the way.As for the scraper/pry bar ends, I'd make them asymmetrical similar to what you did in your last photo but ensure the shorter pry tongue is finished in a way to be used as a large flat head screwdriver, so a little thicker than the other pry tongue.
For the bit tension bar....this could be designed in a way to double up as a pocket clip too. You could also add knurling or jimping on the inside of the bar.
Just some of my thoughts...that's all. Keep the dream going!

-
-
-
-
-
-
Personally, I think this would be a good accompaniment to any thinner multitool that doesn't include accessories such a as a file. Plus, I wouldn't be afraid of getting this confiscated if I carry it in a place a knife isn't allowed, as there's no blade.
If this knife is ever offered for sale, I'll buy it!
One change is needed though. Since there's a slot for a screwdriver bit, the screwdrivers are a little redundant. I think the edges need to be flat and rounded off.
-
-
-
-
-
-
-
-
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login

