Scissors spring repair-- what am I doing wrong???
-
I got a six-pack of large scissors replacement springs from FelineVet today, and spent about five hours trying to wiggle, squeeze, and finagle a spring into place, on my used Space Shuttle SAK, with no success. I watched the few vids on the topic, here and Utube, that make it look so easy, which makes my frustration worse.
The broken spring popped out easily enough, with a small nail and brad hammer, but I seem to be missing something about installing the replacement with pliers. I've tried angling it in from the front, the back, sideways if I could, but no luck.
Can the pros at this give any tips on what looks to be so simple a job?
Matt in Texas
Sent from my SM-G900T using Tapatalk
-
Are you sure you are pushing them from the correct side?
One side of the scissors is wider and sloped, and the new spring can only go in from the sloped side.I never used any fancy kits, just a short nail as guide and it never took me more than 30 seconds to replace a spring.
-
On the Vic spring repair kit, there is a pointed chamfering tool that helps you properly align the new spring in the hole by preparing it to accept the spring. That made the difference in my installations...couldn't do it with out the kit.

-
Sometimes you need to file the edge of the spring so it is sharp and tapered. Also I usually use a set of big pliers to squeeze it in while holding it in the correct position. I have the scissor repair kit and find it to not work well at all.
-
I use pliers as well.
90% of the time, I am done in 10 seconds, the other 10% is like GigaHz said, I have to shape one side to "grease the skids"
-
Well......I just bought the kit to pick up chicks. ;D
-
And? Does it work?? :D
-
Thought you might be the one to ask that......
-
And? Does it work ?

:D -
...yes, you may get arrested for asking people if they want to see your sak ....strange w orld.
Corwin's system must work better, as shown by his gaw

-
An Optivisor helps. Magnifying the slot one can see exactly how the thing has to go in. Now align the new spring with the anchor hole, and with a good pair of pliers, press slowly and evenly and it will go in.
You may have to stretch the spring along the body of the scissors or pliers a bit, that is flatten it out to get the thing to go in. Just work steady, and after your first one, the rest go easy. Trust me. I do this a couple of times a year. Yes I do use my SAK a lot.
Which is one of the reasons why I bought the new EVO S54 - no spring.
-
FINALLY!!! [emoji1] It took a lot of filing to taper one side, and it squeezed in, after about a dozen tries to check the fit.
Some of blades are still stiff to open, and as a work-around I've got a small steel washer on the lanyard, to use as a stronger fingernail for opening the stubborn ones.
Matt in Texas
Sent from my SM-G900T using Tapatalk
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login




