Pliers and screwdriver?
-
I just saw this Irwin tool thread here and was wondering whether there's something like the Knipex 86 03 125 integrated with a 1/4" bit driver. Then I found the SpydeRench which is even closer to what I imagine but perhaps the 9/16" the wrench opens is not enough -- I just would like to be able to fix dripping old pipes and so on. Not an expert by any means, I do not know what's the standard for pipe sizes. Oh and I really do not want a knife on it because sooner or later the TSA would have it :)
Edit: on further research, I found the Leatherman Crunch. If the knife blade would be removable... that looks pretty good.
-
If you are willing to put a little effort into it, you can replace the blade on the Crunch with another tool, or a washer. Assuming the tool end of the Crunch is the same as other tools from the late 90s (PST ii, SuperTool etc.) You can disassemble like this. This can be done fairly easily with a lighter (for loosening locktite in pivot), and use two pliers (preferrably locking vice grips, or engineers pliers) o loosen hte pivot, one to hold the barrel, the other to turn the screw. Unfortunatly, because the Crunch is so uncommon, and hard to find cheaply, there isnt a lot of information on which side is the screw or barrel, ir what fit in place of the blade. Also this will void the warranty. If you decide to try to go through with this, im sure someone over at the Mod Squad can help.
Alternativly, you could just break the blade off at the pivot, and file down the sharp edges, although this may make some of our members take up arms and accuse you of blasphmey and defamy
-
That's frightening :) I was hoping it can be opened like the new ones with a Torx.
I am now thinking Engineer TWM-08 for a wrench and the Doc Allen's VersaTool for a screwdriver. Won't happen in a single one.
-
Its not that scary, think of them as nuts and bolts instead of some weird fastening method, as opening with pliers is identical. (Grip nut and bolt, twist nut, hold bolt)
Kershaw makes something like the crunch, (A1000?) With exposed pliers though
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login