Maglite Led 3d flickering problems
-
@anditsgone said:
As soon as i start to walk or move a lot and the battery's inside the tube start to move it starts to flicker ...This is just a generic answer as I don't have any Maglites but is there a clue there which needs to be eliminated

And in the same context eliminate any possible battery undersize issues, particularly length.
-
As soon as i start to walk or move a lot and the battery's inside the tube start to move it starts to flicker ...
This is just a generic answer as I don't have any Maglites but is there a clue there which needs to be eliminated

And in the same context eliminate any possible battery undersize issues, particularly length.
I know this seems logical but it did not had these problems when it was a couple months old, and i have thoroughly cleaned the contact areas so bad connecting cant be the problem.
-
@anditsgone said:
I know this seems logical but it did not had these problems when it was a couple months old, and i have thoroughly cleaned the contact areas so bad connecting cant be the problem.It could be if the battery cells are rattling/monving inside the tube. ;) You could try bringing the spring to sit a little higher or wrap the cells with some paper/tape and see if that helps.
-
@anditsgone said:
Anyone has a fix for this?Yes ->
<-I had a LED Solitaire that used to do the same.
-
Could be a bad connection somewhere in the head. :-\
Maglite have a warranty to cover this sort of thing though, it would be well worth your time checking it out.

-
Could it be as simple as the spring losing some pressure? Over time and bouncing around it loses its strength?
-
@NKlamerus said:
Could it be as simple as the spring losing some pressure? Over time and bouncing around it loses its strength?That would be my first guess and first plan of action.
-
The spring offers enough pressure to make good contact. it even pressed the + side of the d cell a little bit inwards.
I wil buy another set of battery's to see if it makes a difference. Although this set still has 70 to 80 percent of their capacity left.
I really like my Maglite but if there is one thing i would absolutly hate about a light is if it goes dim at the worst moments. And unfourtanly it does that
-
I know how it feels, my Preon 2 does the same thing. At the WORST possible times.
-
@anditsgone said:
The spring offers enough pressure to make good contact. it even pressed the + side of the d cell a little bit inwards.
I wil buy another set of battery's to see if it makes a difference. Although this set still has 70 to 80 percent of their capacity left.
I really like my Maglite but if there is one thing i would absolutly hate about a light is if it goes dim at the worst moments. And unfourtanly it does that
That's tough. It seems like the members who buy lifetime warranty american made products have trouble with them and sending in for warranty would be a big pain, but the American members buy the same light and never need to use the warranty. I feel bad for you guys. :(
I would call or email Maglite and see if they are willing to send you some parts to maybe fix it yourself. They might be inclined to do this since you live so far away and it will be cost efficient for everyone. Can't hurt to ask. If they say no they there is always a way to get what you want.
-
In my many years of using Maglites, I've encountered this issue a few times and the problem has always been the spring getting squashed down, as others have mentioned.
The first thing I was do is grab my Leatherman and stretch that spring out a bit. Another thing that sometimes helps with the bigger lights (anything over 2 cells) is wrapping a bit of tape around the batteries to "fatten" them up a little and reduce lateral movement. -
The cheap Aluminum barrel flash lights seem to be unreliable with intermittent connections, so I bought an expensive SOLITAIRE made by Mag lite. Ultimately, it too seem to have problems, and I was nearly ready to trash it. The light would come on full brightness, and then go out. If I fiddled with it, the light would flash on, and then quit. Sometimes it would stay on for a few seconds; other times it quit almost instantaneously. It seemed like a classic bad connection problem.
Just to rule it out, I checked the battery and surprisingly found it to be really weak, 1.2 volts. A new battery cured the problem. I didn't suspect bad battery because bulb, when it came on, was at bright <u>full </u> brightness. Bottom line, always check battery.
-
@LAwindsurfer said:
The cheap Aluminum barrel flash lights seem to be unreliable with intermittent connections, so I bought an expensive SOLITAIRE made by Mag lite. Ultimately, it too seem to have problems, and I was nearly ready to trash it. The light would come on full brightness, and then go out. If I fiddled with it, the light would flash on, and then quit. Sometimes it would stay on for a few seconds; other times it quit almost instantaneously. It seemed like a classic bad connection problem.Just to rule it out, I checked the battery and surprisingly found it to be really weak, 1.2 volts. A new battery cured the problem. I didn't suspect bad battery because bulb, when it came on, was at bright <u>full </u> brightness. Bottom line, always check battery.
I have a ton of issues out of "Insert store brand here" aluminum barrel lights. Drop 'em once and they're trash.
My Streamlight Sidewinder was flickering pretty bad, and outright cutting out. This is a light that is used an hour a night pretty much. I checked the battery saying to myself "I just put this battery in a month ago, it should be good". Terminals were corroded, and batteries showed signs of leakage. Duracells of all things. Supposedly the best there is. I've switched to Energizer as of late. Even Maglite is no longer packing Duracells with the lights. My AAA Mini Magilte had Rayovacs.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login