Style blade point
-
As cap very well put, there is either something in the backspring/blade tang area. Or the blade was not cut to proper size. If there is nothing (dirt, chips etc) on the tang, you could grind the ricasso area until the tip settles down inside the handles, but assuring the edge does not touch the inside of the handles. Or, IMO easier, just grind the tip.
-
Thank you guys.
I can send it back. The general agent here will probably exchange it, no need to send overseas. The warranty service is excellent, just thought it was minor and maybe had a quick fix.
I can see that grinding The tang a bit could fix it but would be a delicate operation and if I screw up it would probably void the warranty. -
That is a good point, if you were to have a more severe problem (knock on wood) in the future you would have to figure it out by yourself.
-
Solved! Actually I looked at it again and found the folded metal that works as a back spring was a little higher inwards so that it catches the tang in a higher position than it should. I could bend or grind that part but I realized there was room for a spacer so that the blade would end up a little further out.
I dismounted and added the spacer and now the blade is deep as it should and no risk of cutting myself reaching into the pocket.
For a more serious blade i might not have gone for such solution but it wotrked perfect in this case.
I´ve added (lousy) photos of the result and the tool dismounted. -
Glad to hear it all went fine!!!
-
I have a hard time opening the blade on mine. I intend to add another nail nick closer to the tip.
Good fix by the way!!
Sent from my XT1563 using Tapatalk
-
@JP said:
I have a hard time opening the blade on mine. I intend to add another nail nick closer to the tip.Good fix by the way!!
Sent from my XT1563 using Tapatalk
They could change the position of these "decorative" holes and the nail nick, or better yet get rid of the holes. They serve no purpose and only collect gunk.
You could try to losen the pivot torx screws a bit. I did that and it opens easier. It actually also helps the tension/bar or backspring to snap the blade in both open and closed position so the blade snaps better and the same time as it´s easier to open. However it is a balance so that you don´t end up with a lot of blade play.
Use red Loc-Tite that hardens slowly to fix the torx screw, so you have time to find the right tension before the Loc Tite hardens and then let it cure without touching for a good hour.Red Loc Tite is quite soft so you can easily do it over if you get it wrong.
Mine is a lot better now in all aspects. -
@JP said:
I have a hard time opening the blade on mine. I intend to add another nail nick closer to the tip.Good fix by the way!!
Sent from my XT1563 using Tapatalk
Another option, though not reversible, would be to grind the blade tang a bit. You can tune how much tension you want when it opens or when it closes.

-
Good problem solving skills

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login