Leatherman MINITOOL Mod Possible???
-
G'Day,
Got my Mini-tool today, an unintentional purchase. ;)
I have not dismantled the tool, and will probably not in due course. But, did a few comparisons. There is no way a Phillips from a PST or PST II will fit in. The head is to wide to fit in next to the plier head. Length is OK though. One can possibly remove some material from the outer "sleeve" but that will compromise the integrity of the handles.
On the other hand it looks like a medium or large flat head will fit. Length wise it is not a problem and width wise looks fine too. The only other issue might be the back of the tool and opening mechanism. That can only be verified with the tools out. The nail nick might be on the wrong side too.I have a few shots just to show the length, width is a little more tricky. I hope this helps.
Cheers,
Pete
-
MAybe you could fit in the 2D Phillips out of a Wingman/Sidekick or from one of teh Gerbers with 2D Phillips?!
-
If that Phillips head only likes a little bit then perhaps you could grind it down closer to a 2D version

I am actually surprised that it is that close to fitting :o Perhaps there is hope of a mod after all :ahhh :ahhh :ahhh
:D -
@lowtech said:
MAybe you could fit in the 2D Phillips out of a Wingman/Sidekick or from one of teh Gerbers with 2D Phillips?!Not without some major grinding. The Sidekick/Wingman Phillips, while thinner than the 3D Blast/Fuse/Kick/Rebar Phillips, is still a fairly thick tool. If the PST phillips is comparable in size to the SOG Phillips, it would be about 1.5 times too thick.
And won't most Gerber Phillip's drivers have too little in the pivot area to "catch" the minitool's spring?
-
I am not sure, I have not seen a dissected Minitool. I was just thinking out loud.
-
I have received a PST 3d phillips, I think it is possible to file it to 2d phillips like in a Micra...

-
-
I'm trying to make the bottle opener from the micra work, I think with the right washer I can get it to work.
Sent from my SAMSUNG-SM-N920A using Tapatalk
-
I have received a PST 3d phillips, I think it is possible to file it to 2d phillips like in a Micra...

From the picture above it does look doable :o
Pics if you can get it to work
:DWhat you cannot see in the pic is that the driver hides the "inner" handle of the Mini-Tool. If you start grinding you will have to make if flat like the Micra one.
Micra one may fit, but I think that you will have to make the pivot hole bigger and space it with a washer or two.
Pete
-
I have received a PST 3d phillips, I think it is possible to file it to 2d phillips like in a Micra...

From the picture above it does look doable :o
Pics if you can get it to work
:DWhat you cannot see in the pic is that the driver hides the "inner" handle of the Mini-Tool. If you start grinding you will have to make if flat like the Micra one.
Micra one may fit, but I think that you will have to make the pivot hole bigger and space it with a washer or two.
Pete
Yeah I gotcha now
I wasn't thinking about the other part of the handle in there 
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login