Leatherman Wingman with bit Driver
-
@PTRSAK said:
So you cannibalised a Wave to mod Wingman? :ahhhMan, I though I was the only one who did crazy stuff like that (1908 awl into a 93mm Alox)
hack onLOL, I bought the spare parts on Ebay. The seller said that he found several Wave parts on a garage sale.
My first option was the Wave but like many of you I love to mod and use my hands so I bought the Wingman and the spare parts.
-
Welcome!
I love it when people introduce themselves with mods too :D
-
Great mod
and welcome to the forum ! -
The bit changer is an asset to any tool. Nice mod, even if it did come from a Wave
though I've never liked the precision driver - IMHO a waste of valuable tool real estate. Unfortunately I don't have a spare bit changer.My favourite accessory, well only accessory, is the Removeable Bit Driver kit. So for commonality with my other LM MTs with standard 3D Phillips I adapted the Wingman driver.
Note the missing screw and empty tool bay - work in progress

-
@pingu said:
The bit changer is an asset to any tool. Nice mod, even if it did come from a Wave
though I've never liked the precision driver - IMHO a waste of valuable tool real estate. Unfortunately I don't have a spare bit changer.My favourite accessory, well only accessory, is the Removeable Bit Driver kit. So for commonality with my other LM MTs with standard 3D Phillips I adapted the Wingman driver.
Note the missing screw and empty tool bay - work in progress

First of all thank you everybody most of the inspiration was this forum. I actually use a lot the precision driver. I’m control engineer and several devices use very small screws, this feature in the Charge saved me a couple of times. After I got the spare parts I used a Socket Hex Bit Holder with 1/4-Inch Drive adapted to the flat screw driver of the Wingman, this solution worked but felt really cheese. Your approach looks a much more consistent when someone does not have spare parts.
Greetings from Mexico. -
@pandrosof said:
... I actually use a lot the precision driver ...That's the beauty of modding. Make a better tool.
I've added a precision driver to the bit changer kit. Was a small hex from a precision driver kit. Ground on two opposite faces, epoxy encapsulated and trimmed to size. Could have used the LM bit but TBH mine, particularly the crosspoint end, wasn't well formed. The precision keychain dangly can also provide a bit source.
-
I just tried this mod, but I couldn't get the pins out easily on a Wave or Charge. How hard did you have to tap to get them out?
-
@Tom Munch said:
I just tried this mod, but I couldn't get the pins out easily on a Wave or Charge. How hard did you have to tap to get them out?They tend to be a little tough to get out in general.
I usually unscrew it all the way, screw the pivot screw back in 2-3 turns, and smack the tool, protruding screw first, into the table.I just now realized how bad that sounds for the tool.

-
That's what I did, but I was afraid to really whack it for fear of bunging threads. I'll try again.
-
It could be that the flats on pivot may be stuck to the frame. Try a little twist while tapping.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login