What SOG are you carrying now?
-
@ThePeacent said:
that looks a nice well used hatchet you got there.👍🏻I like to use my tools as much as I can, so I stick to durable stuff...

knives, saws, MTs...they must be up to the task

and the SOG sure feels built to last!
-

That's us mobile
-
Bam! Nice load-out, Nate

-
Thanks!
That's us mobile
-

That's us mobile
-
-
Yes please!

-
Cutter? The seat beat cutter?
That's us mobile
-
@Wanimator said:
Is it true that the cutter and can opener snag on eachother?Yes. If you try to put them right up against each other, the small screwdriver tip snags on the rivet/blade on the V-cut. But, you can easily find another spot for them. For instance, the V-cut is supposed to be a left-side tool, but I have mine on the right (on my PowerLock) - I put a washer against the handle and then put the V-cut. It rubs the handle a little but it is flexible enough that it's no biggie.
-
Is it true that the cutter and can opener snag on eachother?
Yes. If you try to put them right up against each other, the small screwdriver tip snags on the rivet/blade on the V-cut. But, you can easily find another spot for them. For instance, the V-cut is supposed to be a left-side tool, but I have mine on the right (on my PowerLock) - I put a washer against the handle and then put the V-cut. It rubs the handle a little but it is flexible enough that it's no biggie.
Ah, or it could be traded out for a blade ie a plain edge or serrated blade.
-
Is it true that the cutter and can opener snag on eachother?
Yes. If you try to put them right up against each other, the small screwdriver tip snags on the rivet/blade on the V-cut. But, you can easily find another spot for them. For instance, the V-cut is supposed to be a left-side tool, but I have mine on the right (on my PowerLock) - I put a washer against the handle and then put the V-cut. It rubs the handle a little but it is flexible enough that it's no biggie.
Ah, or it could be traded out for a blade ie a plain edge or serrated blade.
Of course it could
that is the beauty of most of the SOG tools - just mix and match until you figure out what you want to do. However, I was looking to replace the blade on my PowerLock. I wanted it knifeless. You see, my PowerLock is my on-duty tool, and I always carry a dedicated folder while I am on-duty. I dislike redundancy. So why not run the V-cutter in its place? I like it a lot, it is very useful -
Nice!
That's us mobile
-
How are the SOG scissors?
-
They are not bad, but they are no where near as good as the ones on a Surge.
That's us mobile
-
@Wanimator said:
How are the SOG scissors?They vary. In general, they aren't as sharp or cut as well as Victorinox (ANY model) or Leatherman Wave/Charge scissors, and not quite as good as LM Juice or Wingman scissors, but both bigger and better than most Gerber "Fiskars" scissors. If you get lucky, they cut pretty well, but a bad set will drive you crazy.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login






