Loose Handle Fix?
-
Anyone? I'd love to try and rebuild this in the next few days, beach sand and salsmurfer have done their work
-
I thought that tightness was governed by how tight those security torx were? I havent fiddled with leathermans in awhile though, but if its not the plier pivot it must be those.
-
Mark approx where the plier pivot sits when inside the handle.
Remove the scales.
Hammer (or use vise etc) to close the channel slightly where you marked. -
</post/1061505>
-
That is exactly the thread I couldn't find!!
-
Uuhhhh......my New Wave closes to this point then takes a little extra to fully close


And the one handle slides this far in my pocket, tried bending in a vice and tapping on an anvil but nothing

-
Take all the tools out from the inside and see if it closes properly
If it does put one tool back in at a time and check it, if it doesn't close with the tools out then it may be something going on with the pivots or the plier head ??? -
@Poncho65 said:
Take all the tools out from the inside and see if it closes properly
If it does put one tool back in at a time and check it, if it doesn't close with the tools out then it may be something going on with the pivots or the plier head ???Gotta be the pivots or plier head. I may try to snap off the plier head rests.
Most of my LMs do it but this is the worst for sure.
-
Take all the tools out from the inside and see if it closes properly
If it does put one tool back in at a time and check it, if it doesn't close with the tools out then it may be something going on with the pivots or the plier head ???Gotta be the pivots or plier head. I may try to snap off the plier head rests.
Most of my LMs do it but this is the worst for sure.
You can remove the whole rest and lock piece with a pair of pliers and some gentle wiggling.
You can then re-peen the rivet for the locks.
That should free up a good amount of extra space in the tool.
I tried just snapping he plier rests but found that they never snapped where I wanted them to and half the time I ended up removing the piece entirely and re-peening the rivet anyway.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login