What Traditional Knife are you toting today?
-
Beautiful choices guys!!!
S&M Heritage Jack

-
Thanks for the compliments guys
Today has been a great day for traditional knives and pics. Nice work folks 
-
Steve that is a great looking TL-29

SAK Guy, 1 or 2 blades, it's hard to beat a jack. -
Thanks Dean

Nice one Robert

-
Thanks guys!!!
-
My Case Sow Belly arrived this morning so has now found its way into my pocket.
-
Nice one Mark. Initial thoughts?
-
@50ft-trad said:
Nice one Mark. Initial thoughts?Well it's obviously well made and sharp too. It's also finger nail breaking tight, do these loosen up my over time?
-
The backsprings are quite keen on my Case slippies, but not what I would consider nail breakers. There's been no softening of the springs on mine either (note, all mine are different models to yours)
-
If it's been peened a little tight, then I would expect that to loosen up a bit after some use
-
@50ft-trad said:
If it's been peened a little tight, then I would expect that to loosen up a bit after some useThat's what I was thinking, it's too pretty to not persevere with it

-
@50ft-trad said:
Nice one Mark. Initial thoughts?
Well it's obviously well made and sharp too. It's also finger nail breaking tight, do these loosen up my over time?
Be sure the joints are clean. I've seen some recent Cases that were tight and full of polishing compound. Cleaning and lubing with mineral oil brought them back to the perfect walk and talk.
-
@50ft-trad said:
Nice one Mark. Initial thoughts?
Well it's obviously well made and sharp too. It's also finger nail breaking tight, do these loosen up my over time?
Be sure the joints are clean. I've seen some recent Cases that were tight and full of polishing compound. Cleaning and lubing with mineral oil brought them back to the perfect walk and talk.
Thanks, I'll try that as well

-
That's a real beauty mate.

-
@50ft-trad said:
Nice one Mark. Initial thoughts?
Well it's obviously well made and sharp too. It's also finger nail breaking tight, do these loosen up my over time?
Be sure the joints are clean. I've seen some recent Cases that were tight and full of polishing compound. Cleaning and lubing with mineral oil brought them back to the perfect walk and talk.
Thanks, I'll try that as well

I usually use toothpicks and/or pipe cleaners to get out any visible "stuff", then flush the joints with oil several times, until the oil comes out clean--not black.
-
@50ft-trad said:
Nice one Mark. Initial thoughts?
Well it's obviously well made and sharp too. It's also finger nail breaking tight, do these loosen up my over time?
Be sure the joints are clean. I've seen some recent Cases that were tight and full of polishing compound. Cleaning and lubing with mineral oil brought them back to the perfect walk and talk.
That's good advise :salute
, unlike SAK's the final finishing can leave behind some residue and/or metal dust.
There are lots of ways to do it but I use WD-40 to flush the joints out. Because it's always here and most of it evaporates, leaving behing only a film.
Blow it out or give it time to dry. then use your favorite oil on the joints. -
Today's carry with the finished Yeoman.

-
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login

