ReWave, Wavebar, etc.
-
Oh and I'll try to get some better pictures in the daylight.
-
GJ

-T -
Looking good so far
I love how each person even with the same idea can have a totally different configuration that suits them individually
Can't wait to see 2.0
Oh and enjoy the new creation you have made
It is always a great feeling when you get a tool together and then get to use it and it works out the way you want it to 
-
Looking good

Couldn't you just replace the can opener with the Rebar awl ?
-
Looks great!
-
@eddie1115 said:
Thanks everyone!Looking good

Couldn't you just replace the can opener with the Rebar awl ?
The awl is about .4mm thicker than the can opener. So it might fit, but the lock tab would have some wiggle. So I could either thin out the awl, or grind the can opener. We'll see...
Either way before and after pics would be a plus
:D -
Thanks everyone!
Looking good

Couldn't you just replace the can opener with the Rebar awl ?
The awl is about .4mm thicker than the can opener. So it might fit, but the lock tab would have some wiggle. So I could either thin out the awl, or grind the can opener. We'll see...
Either way before and after pics would be a plus
:DAwesome job. It's a great feeling to have a tool that suits you for your needs.

As for swapping the awl and opener, the wire stripper notch on the opener is also there for clearance against the side (the locking tab pivot), so it would take some work on the awl to get it to fit down in there. It can be done, just something to keep an eye on, especially if you put a lot of side to side pressure on the awl. It will be more prone to flexing after making it fit.
I think.

-
Thanks everyone!
Looking good

Couldn't you just replace the can opener with the Rebar awl ?
The awl is about .4mm thicker than the can opener. So it might fit, but the lock tab would have some wiggle. So I could either thin out the awl, or grind the can opener. We'll see...
Either way before and after pics would be a plus
:DAwesome job. It's a great feeling to have a tool that suits you for your needs.

As for swapping the awl and opener, the wire stripper notch on the opener is also there for clearance against the side (the locking tab pivot), so it would take some work on the awl to get it to fit down in there. It can be done, just something to keep an eye on, especially if you put a lot of side to side pressure on the awl. It will be more prone to flexing after making it fit.
I think.

The rebar awl should just drop in as is.
But the plier head may sit higher on it and affect whether the handles will close all the way.
There are ways around this problem but don't stress over it until needed because it doesn't always happen.
Personally I prefer the st300 awl and it isn't that hard to resize the pivot the fit.
The rebar awl lacks the little groove but it's still miles better than the signal awl.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login