Lanyards but why?
-
Ever since 1963 I have worn a lanyard (just a length of paracord) with a Victorinox. At that age it was an expensive and treasured tool I received as a gift and could not afford to replace. But on a motorcycle camping trip I stopped to walk a little way along a wild stream to make lunch. After all was packed up, I walked away from my knife, left on the bank, and drove another hundred miles on before discovering my loss. It was impractical to go back.
When I could afford to replace it, I swore I would always wear a lanyard long enough that the knife could be used without removing it. I knotted the lanyard tightly to the knife and ran my belt through a loop at the other end, purposely making it inconvenient to remove. If someone else wanted to use the knife, I told them to "snuggle up".
I have only lost one knife since, and that was when I got careless. I was hiking and for some reason the lanyard was not attached to my belt: the loose end evidently caught in brush and was jerked out of my pocket.
The lanyard has never caused me any inconvenience: I usually carry my knife in a pocket on the leg of my cargo pants, so the lanyard hangs straight down, out of the way. (But in a side pocket, there is little lanyard exposed, so still no problem.)
Recently, I have kept a small carabiner tied to the lanyard so that I can remove the knife more easily if I MUST do so. The dangling, weighted lanyard is a reminder to reattach the knife. The caribiner has proved useful for securing other "must not lose" things, such as keys. I attached a D ring to a travel wallet, and I thread the lanyard through it when traveling abroad (after a wallet once fell out of my pocket in a taxi).
I'd say a lanyard has prevented a good many losses over my lifetime, and certainly spared me much worry.
Crank
Seeking Knowledge, Hoping for Wisdom -
Welcome to the forum Crank.

I did try for one hike a long lanyard as you describe but found I kept catching it on things. In fairness though I suspect I didn't give myself enough time to get used to it.
-
I dont leave a lanyard on the tool when I use it, but its my preferred way to carry any tool. I like the SAK or MT attached to me so I dont lose it and it also keep it vertical in the pocket if you have it just the right length.

-
I find the lanyard very useful for retrieving tools fast and quick from their sheaths or pockets



Adds security and confidence in the grip, too
-
I normally don't put lanyards on my stuff because I found them distracting and cumbersome, but lanyards do help a lot on knives with wave feature.
-
I like them for the fact they can make items without a pocket clip (mt or knives) easier to access from your pocket or watch pocket. It can also give you a 2nd/3rd or 4th finger grip on a smaller knife, like the gnome for example lol. But just as a styling cue, nah, has to be functional AND stylish ya dig!
But. I've noticed on my gerber dime it completely gets in the way of using the flat head I believe. And on my rebar it completely got in the way of using one of the tools too, or hindered the pe blade for any kind of cutting. (I don't remember exactly as I have since removed them a while back)
-
When I use big, two handed tools (shovel, adze, etc.) they allow me to drop them and have a better grip and leverage while still having them in the hand.


Has proven useful so far in a couple occasions (the Gerber with lanyard, the Spyderco can be dangerous if you are not aware)


-
Welcome to the boards Crank.

-
My guiding rule for lanyards is: use it, if it's useful. For SAK's and other multitools I have lanyards that clip into the keyring and clip onto a belt loop. When it's time to use them I pull the knife or tool out of my pocket with the lanyard then unclip it. The lanyard goes back on when I'm done. As far as permanent lanyards I'm not a big fan, with one exception, my flash light has a permanent lanyard that wraps double around my wrist. Sometimes when I am using a knife or tool over and over I will leave the lanyard on and clip the free end around my wrist. I made one paracord lanyard braided in a chain sinnet, (daisy chain), braided it's the right length to clip around my wrist. If I pull out the braid, (takes three seconds), It can be tied into a neck lanyard. I am considering modifying my set up to add a very small clip to my SAKs so that I can simply clip onto a paracord line rather than a proper lanyard.
-
I used to have lanyards on any sigle tool/sak/flashlight, but now that I made some Ti clips those are replacing the former...
But today, I decided to attach the microTi clip I made onto a lanyardSo now it is both a clip and a lanyard



Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login