Mora Club
-
Very nice Gaute. Also congrats on the new Mora.
-
Thanks guys! :)
-
Great work Gaute!

I really like the Eldris, the problem for me is that I need to buy two... I really want to mix and match the red and green knifes and sheaths :P
-
I decided I needed a couple new carving knives so I dug out my box of Swedish surplus Mora. I bought two dozen of these sometime on the 90’s. The boxes have $4.95 each written on them, but I vaguely recall a discount for purchasing a full box. Over the years they’ve been given away, re-handled and a few disappeared…I’m down to 7 unaltered ones. They are laminated KJ Erikksson 1/0s..I estimate 60’s or 70’s vintage and probably issued as workshop knives.
These 1/0s and a 106 are my favorite pairing for carving.
First thing I did was to grind down the spines to a long taper…giving me a profile like a beefy 106.. These are old school riveted tangs, so I had to grind and drive them out. I used half of a #2 handle as a template.
I use a standard length brad-pointed drill first…I find using a long drill first normally results in a crooked hole from drift. In this project I drilled a 3/16-1/4” stepped hole because the taper of the tang…normally for a Puukko blade I only drill ¼”



-
The slot is made with a tang saw. I’m using a Japanese Hikimawashi Nokogiri keyhole saw…which at 4” is long enough for most fittings. If I’m lucky, I can get a light drive-on fit for the last inch or so.
The step for the ferrule is roughed out by saw and fitted by carving. Next is to epoxy the blade in. I only use Devcon 2-ton on my knives…one reason is for a longer setting time. I tape up the gaps in the ferrule and clamp the knife tip down…so the epoxy flows and fills any gaps at the front of the handle.



-
I start working the handle shape by “flats”…it helps me keep blade alignment and symmetry.
The progression is roughed out square then hexagon. From this point it’s knocking off the corners, then knocking off those corners…think filing a square bar into a rod.
Birdseye Maple




-
Another pair with unaltered blades and Masur Birch handles. I'm putting knives together to fill a new carving roll.

-
My old carving roll

-
Nice Spork! I love your old roll also.
-

Beautiful work!
-
Those turned out amazing
-
Very nice work

-

Great looking gear/work there Spork

-
What they all said

-
There are much drool over in that pic

-
Amazing work!
-
My 510 with the burner that Tony made for me


-
@Spork, Lord of Lime Jello! said:
I start working the handle shape by “flats”…it helps me keep blade alignment and symmetry.The progression is roughed out square then hexagon. From this point it’s knocking off the corners, then knocking off those corners…think filing a square bar into a rod.
Birdseye Maple
Stunning work as always mate.

-
Awesome stuff guys!!!!
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
