Any problem solvers?
-
Check to see if the tools have side to side play. If so, it's still possible to peen the pins again to make it tight.
Are any of the tools bent?
Otherwise, you may have a bent pin...
Sent from my iPhone using Tapatalk
-
Or one of the tools was forced and got a little out of alignment. Check them.
-
Happens to every SAK I have that has the combo tool.
The combo tool scratches the main blade by closing any of the 2 tools.
Doesn't seem to happen on the ones with the opener layer though.Is it a modded or factory Yeoman?
-
This happens alot with combo tool Saks. You will often see rub marks on the main blade. So that is normal. If it's preventing the tool from closing properly then that is a problem.
-
@Syph007 said:
This happens alot with combo tool Saks. You will often see rub marks on the main blade. So that is normal. If it's preventing the tool from closing properly then that is a problem.Similar thoughts to Syph. All my combo tool SAKs do this. Even when I've redone that layer in a mod. Just seems to be the way it's made.
-
This happens alot with combo tool Saks. You will often see rub marks on the main blade. So that is normal. If it's preventing the tool from closing properly then that is a problem.
Similar thoughts to Syph. All my combo tool SAKs do this. Even when I've redone that layer in a mod. Just seems to be the way it's made.
I seem to remember the same happens with my Compact. Usually the tip of the combo tool hits the spine of the large blade. I then help it slide down until it closes.
:-\
-
This happens alot with combo tool Saks. You will often see rub marks on the main blade. So that is normal. If it's preventing the tool from closing properly then that is a problem.
Similar thoughts to Syph. All my combo tool SAKs do this. Even when I've redone that layer in a mod. Just seems to be the way it's made.
I seem to remember the same happens with my Compact. Usually the tip of the combo tool hits the spine of the large blade. I then help it slide down until it closes.
:-\
That sounds pretty bad. Mine doesn't get stuck, it just rubs a bit on the side
Spoiler:
That's what she said.
. -
Its a factory Yeoman i believe
-
This happens alot with combo tool Saks. You will often see rub marks on the main blade. So that is normal. If it's preventing the tool from closing properly then that is a problem.
Similar thoughts to Syph. All my combo tool SAKs do this. Even when I've redone that layer in a mod. Just seems to be the way it's made.
I seem to remember the same happens with my Compact. Usually the tip of the combo tool hits the spine of the large blade. I then help it slide down until it closes.
:-\
Its a shame cause the scratches on the blade dont look great
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login