Not Really A Mod, But...
-
You should be good to sand down the rivet.

-
Updating with a pic of the knife and the rivet in question;


-
I agree with Zoid

If you worry about sanding off the peen then sand most of it off and then take a small ball peen hammer and flatten the end out just a wee bit

-
Alrighty, next time I have time I'll sit down with the Dremel and shave it down a bit. I've made small mods and repairs to various knives and tools, but messing with rivets is a bit out of my comfort zone.
It's not an expensive knife or anything, but I am planning to carry it, so wish me luck :D -
Good luck
but I think you have got this

-
So if anyone was interested in an update, here it is;
I actually ended up doing the job with a file, because the Dremel seemed a bit extreme for such soft metal.
It worked! . . . Except I did slip once and slice the bone a little

-
I like updates.
I don't have a dremel and can relate to slipping with the file. 
-
I have a Dremel and I can relate both to slipping with a file and slipping with the Dremel. In general slipping with the Dremel is worse since it works through material faster.
-
A safer way is to cover with masking tape and then file.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login