What did you use your Leatherman for today?
-
Used the awl of my Rebar today to help replace a door latch assembly on my truck. Control rods that bridge the gap between interior door handle and the latch, or exterior door handle and the latch...these rods are held in place by thin clips that slide over the tab and ends of the rods. They had to be removed before the latch would come free.
In the pics, the clip in the palm of my hand slides over the tab that the awl is pointed to. Then the blue end of the rod is forced through the hole in the tab, also through the clip. Easy to assemble back up, but it was the toughest, most fiddly part of the job to undo in the first place.
-
Rod, clip, tab mechanism
-
Latch installed in doorjamb with old one in foreground
-
During the process I also used Rebar to remove/ replace the odd Philips screw, and to help pull the nylon tabs that held the electrical harness in place.
The door now closes as it should instead of leaving a quarter inch gap that rattled over every bump and allowed wind and rain in. Back to some semblance of normalcy, althoughthough a 24 year old K1500 Blazer Silverado always presents me with something else to work on.
The heat is not working. That may be the next project before this New England winter.
Knock on wood but although it needs some work, it starts right up and runs as well as my girl's Nissan Murano.
She may not look like much, but, she's got it where it counts.
-
.

-
@ThundahBeagle said:
Knock on wood but although it needs some work, it starts right up and runs as well as my girl's Nissan Murano.She may not look like much, but, she's got it where it counts.
Your girl or your truck?

-
I saw it right after I posted it!
The truck for sure. My girl...? I suppose depending on one's tastes and preferences...whether or not she had seen the original Star Wars to understand that line...and whether or not she happened to be standing over my shoulder as I write this...well, she's definitely got it where it counts.
-
:D
-
Fixed my elderly neighbours tap this morning. She's Devonian and selectively deaf and i'm Jockanese (Scottish), so Mrs Fuzzbucket acted as interpreter.
Now, the PST can't take full credit for the work carried out, but it did take out the little fiddly screw at the top and did all the necessary poking about... with ease i might add!
PST's pointing at what was left of the washer:

-
Nicely done Jock ! :D
-
@Fuzzbucket said:
Fixed my elderly neighbours tap this morning. She's Devonian and selectively deaf and i'm Jockanese (Scottish), so Mrs Fuzzbucket acted as interpreter.Now, the PST can't take full credit for the work carried out, but it did take out the little fiddly screw at the top and did all the necessary poking about... with ease i might add!
PST's pointing at what was left of the washer:

-
Nicely done Jock ! :D
WATCH IT....

Loved that show when I was a wee lad :D
-
Unscrewed and screwed back several bolts with no slots or crosses
[emoji106]


-
@Fuzzbucket said:
Fixed my elderly neighbours tap this morning. She's Devonian and selectively deaf and i'm Jockanese (Scottish), so Mrs Fuzzbucket acted as interpreter.Now, the PST can't take full credit for the work carried out, but it did take out the little fiddly screw at the top and did all the necessary poking about... with ease i might add!
Ha!!! Neighbour's daughter came round and gave me this for my good deed (not the pst though...):

-
Fixed my elderly neighbours tap this morning. She's Devonian and selectively deaf and i'm Jockanese (Scottish), so Mrs Fuzzbucket acted as interpreter.
Now, the PST can't take full credit for the work carried out, but it did take out the little fiddly screw at the top and did all the necessary poking about... with ease i might add!
Ha!!! Neighbour's daughter came round and gave me this for my good deed (not the pst though...):
I assume you must have done something right [emoji1305][emoji2]
-
Used Wave again today to cut a 2mm stranded wire and attach into a metal stick in the ground in order to get my electric outlet grounded again and get rid of hiss and noise while especially playing an electric guitar with single coils. Cut the wire really carefully at first, but I quickly realized that Wave will accomplish that mission with pride [emoji1320]. Then used bit driver to tighten a screw. Will add pics a bit later so you’d have a better idea.
P.S.: now my American Standard Tele sounds bloody amazing again being played through my Mesa/Boogie F30 amp [emoji1305]
-
@alexanderre said:
Used Wave again today to cut a 2mm stranded wire and attach into a metal stick in the ground in order to get my electric outlet grounded again and get rid of hiss and noise while especially playing an electric guitar with single coils. Cut the wire really carefully at first, but I quickly realized that Wave will accomplish that mission with pride [emoji1320]. Then used bit driver to tighten a screw. Will add pics a bit later so you’d have a better idea.P.S.: now my American Standard Tele sounds bloody amazing again being played through my Mesa/Boogie F30 amp [emoji1305]
Nice one!!!
-
Used Wave again today to cut a 2mm stranded wire and attach into a metal stick in the ground in order to get my electric outlet grounded again and get rid of hiss and noise while especially playing an electric guitar with single coils. Cut the wire really carefully at first, but I quickly realized that Wave will accomplish that mission with pride [emoji1320]. Then used bit driver to tighten a screw. Will add pics a bit later so you’d have a better idea.
P.S.: now my American Standard Tele sounds bloody amazing again being played through my Mesa/Boogie F30 amp [emoji1305]
Nice one!!!
Thanks, bud [emoji2]
-
I used my OHT to divide the Lamingtons I brought to cricket in half so they would go further.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
