Dating Explorer
-
c. 1986-1991. Take a picture of the inside of the knife with all the tools open and I can tell you whether it falls more towards one end of that range or the other.
-
Overall, I concur with JazzBass because:
-Tang stamp Rostfrei
-Tang stamp with crossbow
-Corkscrew with groove
-Snap-ring loop seems to be made from a shim as opposed to integrated as part of a back spring
-He is probably more well versed in the magnifying glass datingHowever, I am curious to know...when you open the bottle opener/ larger screw driver, if you experience a half-stop, then this dating Is even more solid.
If there is no half- stop, it is probably Pre-1986.
Also, check the awl. If there is no thread sewing eye present, then it generally could be older - older than 1974 maybe- but a lot of folks have done a lot of work dating just by the magnifying lenses and its housing, so, again, I defer to JazzBass on that
-
RF-
I carried around my 30 year old Super Tinker without scales for a while, too. I kind of liked it. Nothing to shatter if dropped. Makes it a bit thinner...I wish they would just make the outside liner a little thicker, and engraved the cross and shield on it. I'd carry that around proudly. Even better than AloX
-
Thanks! I will take some more photos tomorrow as it's getting late here now.
The only reason it does'nt have scales is because the old ones were really worn and cracked so I'm making new ones from a piece of wood [emoji106]
Sent fra min FRD-L09 via Tapatalk
-
@ThundahBeagle said:
Overall, I concur with JazzBass because:-Tang stamp Rostfrei
-Tang stamp with crossbow
-Corkscrew with groove
-Snap-ring loop seems to be made from a shim as opposed to integrated as part of a back spring
-He is probably more well versed in the magnifying glass datingHowever, I am curious to know...when you open the bottle opener/ larger screw driver, if you experience a half-stop, then this dating Is even more solid.
If there is no half- stop, it is probably Pre-1986.
Also, check the awl. If there is no thread sewing eye present, then it generally could be older - older than 1974 maybe- but a lot of folks have done a lot of work dating just by the magnifying lenses and its housing, so, again, I defer to JazzBass on that
Large V on 4 line tang is '86 on, and no hook is '91 and earlier. So '86-'91 or
to JB. :DI was going to recommend dressing warmly, because explorers usually want to go somewhere cold, like the Arctic or high mountains, or outer space. :P
-
c. 1986-1991. Take a picture of the inside of the knife with all the tools open and I can tell you whether it falls more towards one end of that range or the other.
Does this picture work?

Sent fra min FRD-L09 via Tapatalk
I think he wanted pictures where the tools are visible. Slight changes in the tools are the most common ways of dating the knives. Some people around here have their own extensive lists of signs but there's this site for the rest of us: http://victorinox.metodi.me/91mmtools.php
-
c. 1986-1991. Take a picture of the inside of the knife with all the tools open and I can tell you whether it falls more towards one end of that range or the other.
Does this picture work?

Sent fra min FRD-L09 via Tapatalk
I think he wanted pictures where the tools are visible. Slight changes in the tools are the most common ways of dating the knives. Some people around here have their own extensive lists of signs but there's this site for the rest of us: http://victorinox.metodi.me/91mmtools.php
Don't forget Huntsman's version, said to be more accurate.

</post/1104586>
And read the rest of the topic for some revisions by El Corkscrew.
-
Thanks for the help guys [emoji16] And thanks to your links and threads I can do some research myself also [emoji106] Is it the same for the Pioneer alox too, or is that a whole different story? I have one that I got after my great grandfather, and it could be fun to know how old that one is too.
Sent fra min FRD-L09 via Tapatalk
-
@twiliter said:
Large V on 4 line tang is '86 on, and no hook is '91 and earlier. So '86-'91 or
to JB. :DBingo. Large V sets the start date, no hook sets the end date. The only other clues you can get for this knife in this time period is by looking at the backsprings. Thus...
Perfect - exactly what I wanted to see. This knife definitely comes from the later end of the 86-91 time frame, so let's say 88-91. The thing to look at here is the mag/phillips backspring. Look at this picture I took of some of my knives:

From L-R are a mid 1970s Explorer, a 1987 Battle of St Jakob Passenger, and a mid 1990s Explorer. These show all the changes to the mag backspring that happened during the 1980s. On the left is the original flat backspring. You can see (blue arrow) how it goes under the inner pin and doesn't really support it at all. Victorinox decided that unsupported design could lead to the knife being "pinched" when the 4th pin was peened, so in the early 1980s they added a little round brass spacer around the 4th pin to help support the layer better (middle knife, green arrow). This brass spacer lasts until the late 80s (you can see it here on a 1987 dated knife) until they redesign the entire mag backspring to look like the one on the right. This one has a bump built into the spring to proved the internal support without the need for a spacer (red arrow).
BTW, they also changed the scissors backspring around this time as well. Note the very tip of the older scissor spring is flat (yellow arrow) and the newer spring has a small bump (orange arrow). This change happens around 1987/88 as well. The scissor spring is then redesigned again in 1991 to incorporate the hook.
-
Large V on 4 line tang is '86 on, and no hook is '91 and earlier. So '86-'91 or
to JB. :DBingo. Large V sets the start date, no hook sets the end date. The only other clues you can get for this knife in this time period is by looking at the backsprings. Thus...
Perfect - exactly what I wanted to see. This knife definitely comes from the later end of the 86-91 time frame, so let's say 88-91. The thing to look at here is the mag/phillips backspring. Look at this picture I took of some of my knives:

From L-R are a mid 1970s Explorer, a 1987 Battle of St Jakob Passenger, and a mid 1990s Explorer. These show all the changes to the mag backspring that happened during the 1980s. On the left is the original flat backspring. You can see (blue arrow) how it goes under the inner pin and doesn't really support it at all. Victorinox decided that unsupported design could lead to the knife being "pinched" when the 4th pin was peened, so in the early 1980s they added a little round brass spacer around the 4th pin to help support the layer better (middle knife, green arrow). This brass spacer lasts until the late 80s (you can see it here on a 1987 dated knife) until they redesign the entire mag backspring to look like the one on the right. This one has a bump built into the spring to proved the internal support without the need for a spacer (red arrow).
BTW, they also changed the scissors backspring around this time as well. Note the very tip of the older scissor spring is flat (yellow arrow) and the newer spring has a small bump (orange arrow). This change happens around 1987/88 as well. The scissor spring is then redesigned again in 1991 to incorporate the hook.
Thanks! [emoji2] The knowledge in this forum is awlsome [emoji16] so that means my Explorer is as old as me or close at least. I got it from my dad when I was a kid, so I knew it was "old" but not how old. Much appreciated everyone!
Sent fra min FRD-L09 via Tapatalk
-
Overall, I concur with JazzBass because:
-Tang stamp Rostfrei
-Tang stamp with crossbow
-Corkscrew with groove
-Snap-ring loop seems to be made from a shim as opposed to integrated as part of a back spring
-He is probably more well versed in the magnifying glass datingHowever, I am curious to know...when you open the bottle opener/ larger screw driver, if you experience a half-stop, then this dating Is even more solid.
If there is no half- stop, it is probably Pre-1986.
Also, check the awl. If there is no thread sewing eye present, then it generally could be older - older than 1974 maybe- but a lot of folks have done a lot of work dating just by the magnifying lenses and its housing, so, again, I defer to JazzBass on that
Large V on 4 line tang is '86 on, and no hook is '91 and earlier. So '86-'91 or
to JB. :DI was going to recommend dressing warmly, because explorers usually want to go somewhere cold, like the Arctic or high mountains, or outer space. :P
Right, right. Forgot about the Large V...Thanks for that
-
Large V on 4 line tang is '86 on, and no hook is '91 and earlier. So '86-'91 or
to JB. :DBingo. Large V sets the start date, no hook sets the end date. The only other clues you can get for this knife in this time period is by looking at the backsprings. Thus...
Perfect - exactly what I wanted to see. This knife definitely comes from the later end of the 86-91 time frame, so let's say 88-91. The thing to look at here is the mag/phillips backspring. Look at this picture I took of some of my knives:

From L-R are a mid 1970s Explorer, a 1987 Battle of St Jakob Passenger, and a mid 1990s Explorer. These show all the changes to the mag backspring that happened during the 1980s. On the left is the original flat backspring. You can see (blue arrow) how it goes under the inner pin and doesn't really support it at all. Victorinox decided that unsupported design could lead to the knife being "pinched" when the 4th pin was peened, so in the early 1980s they added a little round brass spacer around the 4th pin to help support the layer better (middle knife, green arrow). This brass spacer lasts until the late 80s (you can see it here on a 1987 dated knife) until they redesign the entire mag backspring to look like the one on the right. This one has a bump built into the spring to proved the internal support without the need for a spacer (red arrow).
BTW, they also changed the scissors backspring around this time as well. Note the very tip of the older scissor spring is flat (yellow arrow) and the newer spring has a small bump (orange arrow). This change happens around 1987/88 as well. The scissor spring is then redesigned again in 1991 to incorporate the hook.
Thanks for the scissors back spring internal details. Now I I'll have to check my Super Tinker. I know about when I bought it, but that doesn't mean it wasn't on the shelf a while first...
-
Amazing details, Jazz. Thanks
-
@jazzbass said:
........
Bingo. Large V sets the start date, no hook sets the end date. The only other clues you can get for this knife in this time period is by looking at the backsprings. Thus...
........
Perfect - exactly what I wanted to see. This knife definitely comes from the later end of the 86-91 time frame, so let's say 88-91. The thing to look at here is the mag/phillips backspring. Look at this picture I took of some of my knives:
.........JB - This level of detail is insane - You never cease to amaze me - And thanks so much for always sharing your knowledge
How do you even spot these super-subtle changes? ??? - Never mind dating them all :o
Going to go and look at all my mag glass knives when I get home
Although I think I had spotted the wee bump/lack of bump on a scissor spring once - then completely forgot abouit it !!
And re the dating sheet (Pabs Reply #8) - New version to be published soon with El CS updates

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login




