Bent awl
-
Is it just the very tip that got bent ? It doesn't look bent too me from your pic

-
In a little test I conducted some months ago, this awl was the best compared to Vic backspring and Leatherman.
Now this one in particular is f'd. I'm sure Vic will repair it. Just curious to see if it is going to be warranty or some cost.
-
That's a Vic for you. Stuff like that happens, but at least it won't explode.
I was messing with an Antonini Cable utility type knife that used "bird's eye" rivet construction, which is a hollow brass piece over the pin. While boring a hole in wood with its (quarter round) awl, I managed to pop the brass piece off and push the liner off.
Vic steel isn't really that hard, so you shouldn't have that much trouble tapping it back with a hammer and small anvil--I've had to do that with two rather old SAKs I got for cheap. The only knife I had trouble straightening was a Browning Tracker small lockback (which wasn't some pile of garbage with the Browning name on it, it was done in the '70s to compete with Buck), and it snapped very easily--it must have been tempered extremely hard.
-

@Don Pablo said:
So...mine's not an awl to admire? OK. Maybe I'll try it again
It takes practice.

-
Many walls in my house are made of plaster. If I need a hole in it, I use a electrical hand drill. Although plaster is very soft, it is also very resilient. When you apply pressure on it, it is very tough, robust.
Most houses in Afghanistan are made of mud, with walls over a meter thick. You can scratch the walls with your knife and the mud will come off. However, if you shoot it with 25 mm HE or APDS cannon rounds, they will only penetrate a few inches.
So, even if the plaster is soft, you still did apply too much force on the awl.
BTW: I think the Pioneer's awl is more of a reamer, because of the sharp edge it has. The 'awling' should be done on leather, cloth or wood at max. -
Reamer might be a more correct name....
But there aren't as many opportunities to use ”reamer” in puns, compared to ”awl”...It would be awlful. :'(
-
I understand the disappointment Thundah, but to me if the knife's a user, I would continue to use it as is and that tip will will wear down on it's own, probably to a point that's stronger
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login