Penny Stove
-
It covers the central holes and seals the chamber so that the vaporized alcohol exits the jet holes. If the pressure builds up too much, it will lift the penny a bit and vent the chamber.
You start by placing the penny over the drain holes and filling the center and outer ring until it covers the jets. This is about 1/2oz of fuel and will bring 2 cups to a boil. If you need more burn time then you slide the penny aside and let it drain into the chamber...replace the penny and fill the top again. In my Swedish Mess Kit setup an ounce of fuel will bring 3 cups to a boil and sustain it for several minutes.
Light the stove and when it gets hot enough, the penny will lift and the remaining liquid fuel will drain into the pressure chamber...the jets should "bloom" when that occurs.
In my photo, I'm using Lab grade Ethanol with red food dye added so that the initial fuel level can be seen.

-
Nice set up!
Mine's a bit more spartan. Everything fits in the pot.
-
Yeah, the Swedish messkit is a bit heavy and bulky for packing...I still like using it though.

-
I did a hack on a cheapie Stansport cartridge stove just for fun :D


-
Also made a lid for it because the top half can't be used for the purpose when hung by the bail.

-
This is the setup I've been using for Backpacking for years...everything fits inside except for the tent stake.


-
This is a new setup I've been working on. The windscreen stand breaks down into two sections so it can be stowed inside...the tent stake/pot supports lock the pieces together when set up. The stand is dimensioned for a Penny stove or a Trangia burner.
I'm thinking about ditching the Ti Kettle in favor of hard anodized aluminum...because Ti is such a poor heat conductor.


-
I just got this Clikstand...I like it a lot but I wish the windscreen was a bit larger in diameter for my kettles.

-
-
Home Depot :D
Get yourself a roll of aluminum roof flashing...avoid the stuff that has a gold colored coating on one side if you can. That coating really stinks when it burns off and is a pain to remove.
All you need is a pair of heavy scissors or shears and a single hole paper punch.
-
Get yourself a roll of aluminum roof flashing...avoid the stuff that has a gold colored coating on one side if you can. That coating really stinks when it burns off and is a pain to remove.
All you need is a pair of heavy scissors or shears and a single hole paper punch.
Balderdash. You think I don't know that all good backpacking gear must be made of titanium and cost three figures? Home Depot indeed! >:(
:D
-
What was I thinking?
:D :D -
Cool setup Spork

Bit complicated for me I believe :ahhh :D
May give it a try sometime just for fun though ;)
-
Something from the prehistoric days...Sterno stove and SIerra cup :P

-
Ancient white gas MSR stove, circa 1976 with original accessories including the aluminum cup and steel scorch buster. The pump is a new replacement. This is my first stove...and I think...the first white gas MSR model.
This one has a built in flint wheel sparker and a pad under the burner to catch spilled fuel for priming...I think the pad is asbestos :ahhh

-



have you seen these?
they were made at halfway of nineties if i remember right.
it has 0,5 liters capacity in the aluminium cup/mug,and the fuel canister is 0,25 liters,and with that amount of fuel you can boil for eternity as the burner is pretty well made and effective.the lid act as pan but its tiny as h-ll,but man can cook some meat or egg in it still.best of all,its just under 100 millimeters( bit under 4" ) in diameter and maybe bit over 5 inches tall when its packed up and ready to be carried in the small red cotton pouch.these never became hit here,due to small size but it has good reputation cause alcohol burners are hard to get broked,and its good for solo hiker,and fits in small backpack more than well.just good size for heating/boiling a cup of coffee or some soup and excactly the size needed to boil water,to be poured into most dried meal pouches.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
