September Storm: 30 days of Waves
-
Good idea woth the anti-slip padding, W!

-
-
@gerleatherberman said:
Good idea woth the anti-slip padding, W!
Thanks GLBM

I was fed up with the knives sliding
about when you open and shut the drawers
-
-
This morning the anti slip material got delivered

So I used the plain blade on the
Wave+ to remove the packagingI used the Wave+ scissors to cut the
material to fit the drawers on my storage boxAgain no problems with the Wave+
I was surprised that the scissors
cut the material without any problemsWow.... that looks really nice

-
Thanks MTMatt

-
** Day 14**
Nearing the end of the week coffee gets more important. The Wave's bit driver helped to maintain order



-
The chest is looking good Speedy

-
fine job Speed! -
Thanks Jaypeebee and Glockfan

-
Tomorrow will be the half way point :o Great job so far to all those who have been faithful to the challenge
Lots of great uses today and yesterday as well 
-
:ahhh :ahhh :ahhh
-
@Obi1shinobee said:
:ahhh :ahhh :ahhhIt’s not that bad Obi

-
Are we going to do a reflection poll afterwards like for Chuck Yeager?
This has been a great challenge so far, with many great uses

-
** Day 14 **
Got a really busy day ahead of me, so here is my daily photo


-
September Storm:

Early delivery, and just in time!
-
Day 14
Received a special package that arrived much sooner than expected. :) Thanks to Kingofswords on another thread an order for the T-shank holder. On first look, it does looks cheap. But it's actually quite sturdy and the cut out of the T shank is very precise. There's no wiggle when the blade is in place. Need to do a bit of filing at the back that meets the liner as it does not engage properly. At least its not the other way round where the liner over travel.



-
@Sam Lim said:
Day 14Received a special package that arrived much sooner than expected. :) Thanks to Kingofswords on another thread an order for the T-shank holder. On first look, it does looks cheap. But it's actually quite sturdy and the cut out of the T shank is very precise. There's no wiggle when the blade is in place. Need to do a bit of filing at the back that meets the liner as it does not engage properly. At least its not the other way round where the liner over travel.

It looks quite nice.

Could you please post more pictures of it open?
Also, does it have to replace a blade? Can it not go in place of the file?
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login


