74mm cap lifter
-
Great mod and it came out really nice.

-
Cool

-
Nice! 8)
But what about weakening the driver by moving the metal? -
@Pablo O'Brien said:
Nice! 8)
But what about weakening the driver by moving the metal?A) It's only a small driver, so torque won't be high.
B) The amount of material left is still about as wide as the blade of the driver, so it;s lo weaker than any other long driver would be.
C) Drink enough beer, and you won't care anyway
-
@50ft-trad said:
@Pablo O'Brien said:
Nice! 8)
But what about weakening the driver by moving the metal?A) It's only a small driver, so torque won't be high.
B) The amount of material left is still about as wide as the blade of the driver, so it;s lo weaker than any other long driver would be.
C) Drink enough beer, and you won't care anyway

-
@50ft-trad said:
@Pablo O'Brien said:
Nice! 8)
But what about weakening the driver by moving the metal?A) It's only a small driver, so torque won't be high.
B) The amount of material left is still about as wide as the blade of the driver, so it;s lo weaker than any other long driver would be.
C) Drink enough beer, and you won't care anyway

I'm convinced.

-
Like this mod!

-
I asked this somewhere else, too. Anyone thought about doing this on the nail file, instead? The tool is thicker and it's normal use puts less stress in it.

-
@pfrsantos said:
I asked this somewhere else, too. Anyone thought about doing this on the nail file, instead? The tool is thicker and it's normal use puts less stress in it.

I did see a picture around here somewhere with a Executive lookalike that did just that, but that was how it was made from the factory. I considered it on the one I made but opted against it on the grounds that the heat treating on the file would be more delicate than on the orange peeler.
-
I asked this somewhere else, too. Anyone thought about doing this on the nail file, instead? The tool is thicker and it's normal use puts less stress in it.

I did see a picture around here somewhere with a Executive lookalike that did just that, but that was how it was made from the factory. I considered it on the one I made but opted against it on the grounds that the heat treating on the file would be more delicate than on the orange peeler.
Any idea where that was? If I were to make it, I'd be using a manual file, so I don't think it would ruin the heat treatment of the tool.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login