THE Crunch Owners Thread
-
Here is the link to my thread about fitting a Kick Pocket clip:
/topic/75590Hope this helps

I got the proper tools from ebay and WOW! are those screw difficult to remove. I'm afraid I'm going to strip the heads... Not to mention those tools are sharp and ripped my fingers apart.
Did you use heat to the pivot

As the pivot has got thread locker
that needs to be made soft again
The other thing you could try
Is to slightly tighten the pivot a bit more
As that will brake the seal of the thread locker
And then you slightly undo the pivot
and then you tighten again
Do that a few times and then it should undo properly
-
Thanks! I'll give that a try.
-
I used a heat gun but you can use a hairdryer as well

-
A lighter works as well ;)
-
Butane lighter works wonders!
...Just a few seconds on each side and the screws will turn and come out very easy.

-
Good one Justin

-
that might get the job done 
-
The PocketCrunch again today


-
When I get home I need to nominate this pic Ws

-
Thanks Poncho much appreciated

-
Thanks David

-
Nice pic W !

-
Thanks Steve and nice pic of yours

-
The PocketCrunch :D

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
