Sharpening Angle Mystery
-
@Micky d said:
Maybe it was just the very tip of the edge that needed sharpening, and the rest of the time on the 20 degree angle, you were just removing/wearing down the shoulders

That makes sense :)
I'm glad it does to someone :D
[/quote]It makes sense to me too, but then I've had a couple..

[/quote]Booze does seem to help people to decipher my ravings :D -
speaking of acute why is everybody messing up the quotes?!

drop the "/" in the first set of brackets!
:D -
@WhichDawg said:
speaking of acute why is everybody messing up the quotes?!
drop the "/" in the first set of brackets!
:DI'm not even sure what we're discussing anymore...but I wanted to get a quote in... :D
-
Could be that it was pretty blunt to begin with and you just weren't getting to the edge. If I find I'm getting nowhere with a blade I take a permanent marker and run it along the edge. After sharpening if you can still see a black line along the edge you just haven't removed enough metal yet and might be better off going with a coarser stone to get you started.
Alternatively there's all the other stuff that's been misquoted in this thread :P
Neil
-
-
I think Neil may be on the right track. During the initial sharpening with the coarser stone, you want to go far enough to raise a light burr on one side, then the other to clean up and set the secondary bevel.
-
Maybe there was a lot of "burned" metal from the initial sharpening in the factory that needed to be removed to get a decent edge. Is it the first time you sharpen this blade?
Carlos
-
-
Maybe there was a lot of "burned" metal from the initial sharpening in the factory that needed to be removed to get a decent edge. Is it the first time you sharpen this blade?
Carlos
That seems to be a good point Carlos

Thanks!
Usually, when i sharpen a new blade, i use a very coarse stone to remove all the steel in the surface, and when i change to finer grits i have better results than when i don't use the coarse stone. Hope this can help.Carlos
-
@NKB said:
Could be that it was pretty blunt to begin with and you just weren't getting to the edge. If I find I'm getting nowhere with a blade I take a permanent marker and run it along the edge. After sharpening if you can still see a black line along the edge you just haven't removed enough metal yet and might be better off going with a coarser stone to get you started.Alternatively there's all the other stuff that's been misquoted in this thread :P
Neil
Great tip.Thank you :)
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
