What Rescue Tool do you use, and why?
-
I have the MAK-1 as well and I like it, but I think Ontario's SPAX is a better fit for my Jeep, as the axe could also be used in the woods. Of course, if I had my way, I'd have both in it at all times!
Def
-
@jzmtl said:
Windshield are laminated and wouldn't break into little pieces and fly off, go ahead and document with video cam.
I'm not a fan of those spring loaded thingy thou, I'd rather have a carbide tip on back of my knife handle, bet I can smack it a lot harder than the spring can. Too bad I've yet to come across a knife I like with it.
Vic disk (glass) saw works on a pull stoke and can send small bits of glass flying.
-
-
Thick aluminum shafted snow brush.... I'm sure the scraper blade can be used to distract someone in that situation...
Def
-
A Vic rescue knife for the car and a Swisstool or Spirit as my EDC . When on lifeboat duties its an Spyderco Atlantic Salt ( now carried on the boat ) and a Swisstool RS .I used to have a Spyderco Assist , great knife but I think the Vic Rescuetool offers more .
Dunc
-
-
-
@dunc5 said:
A Vic rescue knife for the car and a Swisstool or Spirit as my EDC . When on lifeboat duties its an Spyderco Atlantic Salt ( now carried on the boat ) and a Swisstool RS .I used to have a Spyderco Assist , great knife but I think the Vic Rescuetool offers more .Dunc
Pics of my Vic RescueTool in its natural habitat in the car



Over the weekend I will take some pics of the Spyderco in the lifeboat .
Dunc
-
-
Well if you weren't such a Global Tuffy then maybe they would look at you differently! :ahhh
Def
-
-
-
I'd love to do that, but I just know I'd get stopped and searched.

But it says "RESCUE TOOL" right on it, so obviously it can only be used for GOOD!
Surely any copper can see that!It still has a locking blade and sadly that's all that counts.

I would like to think they would use their loaf.
-
I'd love to do that, but I just know I'd get stopped and searched.

But it says "RESCUE TOOL" right on it, so obviously it can only be used for GOOD!
Surely any copper can see that!It still has a locking blade and sadly that's all that counts.

I would like to think they would use their loaf.
Not likely with target's to meet ::)
-
spring loaded center punch is the way to go, everything else is a rip-off.
I speak from 32 yrs. in the fire service.
-
@STXFR5007B said:
spring loaded center punch is the way to go, everything else is a rip-off.I speak from 32 yrs. in the fire service.
Welcome aboard! Most of my fire service time was in a rural/small town VFD before going to EMS.What's been your primary experience?
-
mostly wildland/urban interface with a very liberal dose of metro, rural and "pure" wildland thrown in for good measure.
my current house is in a residential area; the average size home is approx. 3500 sq ft and it goes up from there, we also respond up into the foothills on the eastern end of our battalion.
this house is for the "old" guys and is supposed to be slow

I'm retiring in Sept; can't wait to go, I've had my fill - it's on to bigger and better things!

-
I get the impression you're in So. Cal...and if that's the case I'd be more than ready for retirement after three consecutive brushfire seasons there.
-
naw.....central California, east side of the san Joaquin valley although my dept covers the un-incorperated area from 6000' in the sierra nevada clear over to the montery county line in the coast ranges.
big area; very, very diverse.
all of our engines are rescue engines: we also have a heavy rescue in the central part of the district that responds any where it's needed.
we serve 2600 square miles and 150,000 citizens with 11 engine companies, 1 ladder, 1 heavy/swift water rescue 1 rescue boat 1 squad, 2 brush patrols, 6 water tenders and 1 state oes engine.
our staffing leaves much to be desired, we run 2-0 staffed except the ladder which is 3-0 and 2 engines staffed 3-0. budgets are very stretched as you might imagine.
how about you? what's your dept like?
-
That's a lot of territory to cover with that little bit of resources.I wouldn't want the headache of covering staffing for vacations.
My old dept,like I said was a VFD,serving about 4500 people in 6 sq miles.Apparatus is 3 engines,1 rescue,and one command truck out of one station. I took a look at the most recent TOE,and it's very officer heavy.1 Chief,2 Ass't Chiefs,2 Deputy Chiefs,4 Capts,4 Lt's and 24 FF. When I was there and active I was a Driver/Engineer,I see that my old unit number is now assigned to a Lt.BTW,my great-uncle was a major player in organizing some FD's in Northern Cal,in and around the Truckee area.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login