Calling Reba owners...
-
Hi Max,
clumping, yes.
I was able to leave the washer at the PE blade on though, so that's good
-
and now it's a feature again 
-
I did the mod yesterday, to my 2012 BO Wave. There were a few issues with mounting the Rebar awl into the Wave.
-
The Rebar awl was too long, causing the tip of the awl to overlap the flat part of the Wave scissors when closed. So I actually had to grind down the length of the awl in order to keep the tools from overlapping. If I hadn't done this, the awl would have had to have been opened first, in order to open the scissors.
-
The Wave wouldn't close completely after the awl was installed. So the spine of the awl had to be ground down, bit by bit, until the Wave would close fully.
-
To get the Wave to close fully, the kick for the pliers had to also be filed down. I didn't have time to completely disassemble the Wave, so I just used a small conical grinding bit on my Dremel tool to remove the kick. The grinding bit was able to fit in the empty channel.
-
I had no issues with tool thickness. The Rebar's awl dropped nicely into the slot vacated by the eyeglass bit driver. Lots of room fopr adjustment there.




-
-
Nice work Bb

-
Glad you got it to fit

-
Thanks all.
Nice mod BB.
My plan is slightly different - to move the flat head driver to the middle but loose a little length and I expect grind a little off the 'top' side of the flat driver too to allow the pliers to sit down. I rarely use the fixed flat head (maybe never!) and to lose the length is no issue (for me) and may improve it's sturdiness fractionally as a pry.
And mount the awl at the side (in place of the flat head) as I want maximum length and I hope this will lessen the alterations needed.
-
@Maxintheuk said:
Thanks all.Nice mod BB.
My plan is slightly different - to move the flat head driver to the middle but loose a little length and I expect grind a little off the 'top' side to allow the pliers to sit down. I rarely use the fixed flat head (maybe never!) and to lose the length is no issue (for me) and may improve it's sturdiness fractionally as a pry.
And mount the awl at the side (in place of the flat head) as I want maximum length and I hope this will lessen the alterations needed.
I don't know. The flat part on the scissors is pretty wide. It looks like it'll reach the awl, even when the awl is mounted where the flathead normally lives. You may have to grind off part of the flat on the scissors to get around shortening the awl. I think I'd prefer a shorter awl.
-
@Buzzbait said:
I don't know. The flat part on the scissors is pretty wide. It looks like it'll reach the awl, even when the awl is mounted where the flathead normally lives. You may have to grind off part of the flat on the scissors to get around shortening the awl. I think I'd prefer a shorter awl.It might *just *reach but very minimal work would be needed to get it all to fit I think (ie a sub 1mm diagonal grind of the already radiused outer rear corner of the scissor tab). Have to wait until I get one to be sure. ;)
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login