Clip idea. Thoughts?
-
I’d like you guys’ input on a clip idea I had.
I tried the recommendation someone gave me about putting a suspension clip on a little S-Biner for a quick disconnect on the clip (since I dislike that they always get in the way when I use the awl on my Alox Pioneers). The idea is sound, but it makes my SAK sit over 1 1/2” lower in my pocket and it sits horizontally, which is kind of uncomfortable for me since I feel it against my leg. So I had an idea for a quick disconnect style clip and made a rough “prototype” using a paper clip. When you squeeze the sides together it opens up and allows you to remove it from the ring. I tried it out for half the day and I gotta say I like it. It sits up vertically against the seam of my pocket and makes the SAK less noticeable. I can barely feel it in my pocket. I just gotta figure out how to make one out of better materials.
Any suggestions? Thoughts? Does someone already make a clip this style and, if so, where can I get one?

-
I just use these for quick connects...


Sent from my iPhone using Tapatalk
-
@Manny Sanchez III said:
I just gotta figure out how to make one out of better materials.A fairly straight forward option could be bending spring steel or music wire of a suitable dimension? (If that is not exclusive, springy or corrosion resistant enough you might have a look materials like nitinol, phosphor bronze or beryllium bronze with a suitable heat treat after shaping).
-
@Vidar said:
A fairly straight forward option could be bending spring steel or music wire of a suitable dimension? (If that is not exclusive, springy or corrosion resistant enough you might have a look materials like nitinol, phosphor bronze or beryllium bronze with a suitable heat treat after shaping).Lol, I tried using a small section from a wire hanger and I’m already getting frustrated :D
-
@Manny Sanchez III said:
Lol, I tried using a small section from a wire hanger and I’m already getting frustrated :DA wire hanger can be made of so many things, so chances are the material isn't all that suitable for your purpose. I would look for some material used in springs as suggested above. You then get the basic choice of either: 1. Aiming to bend already spring hard materials into shape, or 2. Bending material in its soft form but then having to heat treat afterwards to achieve strength and stiffness. Heat treating can be less than DIY friendly so number 1 is likely the best choice.
(As you are in the US another alternative might be 17-7 PH stainless steel wire. Usually sold in a form that require heat treat though).
-
Try a local fishing shop. They usually have things like you made. Speed clips, fast locks etc.
-
These are the type of clips I tend to use.

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
