What did you use your Leatherman for today?
-
Put new SATA SSD in T480 laptop near M2 SSD, used a wave+ black for this.
-
Great use buza

-
I needed the multimeter yet one cable broke and i had to resolder it, so here came the P2 for the rescue. Quite happy with the easy axx to the tools, at least for this low force, skilled craftsmanship that i'm doing :)


-
Nice job Raoul

-
The bed started to sqeaq, so i tightened the screws that holds it toghether.
I wish i could say it was I who made the bed qeaq, yet the kids are the ones jumping all day long on it :(
-
Good tool for screws Raoul. The P4 that is.

-
Great job Raoul

-
Been busy today with making the hoses fit the t piece
That I need for fitting a oil catch tank to my car
With the help from the LM ST300 serrated Blade


-
Great use fellas[emoji1690]
Sent from my E6653 using Tapatalk
-
Thanks marko

-
Used the flat driver on the ST300 to open the lid of a spray paint can so I could re spray the side panel from my motorbike as it had damage from a fuel spill :(



-
Good usage and fix there WS.

-
Thanks Max

-
I used my entire EDC today..surprisingly.
I used Tweezers from the Vic manager (to get out splinter), used my Surge multiple times: to help me pick cherries without damaging them, to undo some knots that were too tight to do with my hands. I used my Opinel #8 to cut up some fruit (damn this thing is razor sharp), used my BIC 4 in 1 to keep track of expenditures on receipts and take notes on future products.
All in all a great day.
Cheers,
H.G. -
Great EDC usage HG!

-
Great uses HG

-
These screws needs attention from time to time

-
Great use Raoul

-
I used the new surge to replace a light bulb in my car.

Silly Ford mondeo requires you to take two screws off and a push stud to get to the headlights bulbs. Pray that they don't blow when travelling far from the main roads.
-
@eTripper said:
I used my Wave Plus to help swap a set of revolver-grips from one-to-the other. The Hogue grips slide through a screw-swivel that's attached by bendable tabs, on the revolver-frame. It's actually a lot easier, than the explanation. But those Wave needle-nose pliers were just the ticket!
Here is what the bottom of gun butt looks like with the swivel attached. See the tabs, on-the-pins.


Once the tab is removed from the cross-pin; the VZ grips just snap-on, and are secured by the cross-screw. These are their 'black cherry' in G10.

The Hogues went back-on my Lew Horton 610.

I like your revolver. How is the recoil for a 10mm?
In Australia we are limited to 357 caliber (38, 9mm) and under
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login