What did you use your Leatherman for today?
-
Nice work marko

-
A belt came apart at the pin connector...so we cut up the belt, put new teeth on it.
Used my Rev to chop up a few different size wire pins. Cut like butter.
-
Good job BM

-
Vacuum pump on a tray sleever blew. So...to get to it used to my Rev and Surge philips to unscrew 10 screws holding the wall to the machine.
Used surge plier to loosen a pipe coming off it.

-
Great usages BM

-
Recumbent trike's headrest was out of kilter. Got one side of the double-hex bolt loosened, then adjusted the pad-rest part to the better position. When trying to tighten the bolt up the other side was slipping of course. Pulled out the Crunch and went to see if the Phillips driver would hold it enough to tighten the bolt. The driver went in further than I though the hexed hole was, then it clinched in. Tightened the bolt up, and checked the fitting. :D
Minus the stubborn pliers head, the Crunch comes in handy a lot.
-
Great use

-
I wanted to take a closer look at my Sidekick after all the downing on entry level LMs. I will always think the Rev is a solid entry level.
I had some toys to open (diecast dually trucks, my USPS TT and step van havent released yet) so I used my Sidekick. Ive used it a few times, carried it a handful of times. And now, after examining each tool closely, I only see one fault. Because it is spring actioned, the wireclippers cant fully touch. A non issue for me but others may disagree. However, they do work as needed, unless youre trying to cut something very thing such as floss or fishing lone.
-
Some cutting and screwing,a good day is when you have to use you Leatherman and enjoy it[emoji1689]
Sent from my SM-G960F using Tapatalk


-
Great uses

-
Thanks Ws[emoji1689]
Sent from my SM-G960F using Tapatalk
-
Used the TTi to assist in winterizing the saw and other gas tools.

-
Nice one

-
Nice Charge and usage Jonon

-
A lightbulb died so my girlfriend tried to replace it and the glassy part got separated and left in her hand almost. Signal came to the rescue helping to remove the remaining part and have a lightbulb successfully replaced.


Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login