Antler bone scales build
-
So my knife making friend gifted me a small antler for a custom build. First time working with this material. Quite easy to cut and sand to shape.
Still to decide what build to do, thinking just a simple Climber but with brass liners and exposed pins.
Will do final shape and finishing only once I’ve drilled the pinning holes. Will try to keep as much of the natural finish as possible.




-
Nice

Sent fra min FRD-L09 via Tapatalk
-
Thanks RF52.

May be a week or two before I finish as I’m getting a hole guiding jig fabricated to make it easier to drill scales and liners.
-
Looking good Max

Can’t wait to see what they will look
like when you have finished them
-

Sent fra min FRD-L09 via Tapatalk
-
I love stag and that will look sweet on a SAK for sure

-
Very cool project, Max!

Looking forward to seeing how it looks when you're done!

-
Thanks GLBM, comis, Poncho.

I’d better not mess up, now that I’ve got the big guns watching!

-
That is an awesome project Max! Very interested to see how it turns out.
I love the look of stag scales, especially on a SAK. I've always had the urge for a Huntsman with stag scales and I have a feeling the end result of your project will only make it worse! -
Be sure to use a mask when working with it. I've heard the dust can be very bad for you (well, for anyone, actually...).
Awlso, using some masking tape over the cutting places might help prevent chipping.

-
Thanks pfrsantos, yes I’ve been careful with the sanding. Smells a bit like when the dentist drills a tooth.

-
@Kraken said:
That is an awesome project Max! Very interested to see how it turns out.
I love the look of stag scales, especially on a SAK. I've always had the urge for a Huntsman with stag scales and I have a feeling the end result of your project will only make it worse!Thanks Kraken, not yet decided the model to rebuild. Huntsman would be a good choice.

-
Well Kraken, 6 months later, eventually got around to finishing the stag horn. Took your advice and did a Huntsman. One of my old SAKs that needed a little TLC so was a good project to do.

Wanted only the end brass rivets exposed, so first did the 2.2mm inner rivets and then closed with the outer rivets. Was quite a fiddle to get the end pins through with this method as I normally build up one layer at a time.
Only real issue was that I used a permanent marker to trace the scales and it soaked into the horn. So lesson learnt.
Overall very happy with the result. A nice retro look with the exposed rivets. It will definitely be in my EDC rotation.

I took a few pics during assembly.




-
A few more pics...




-
And all finished...





-
Very nice job!
JR -

That is very well done

-
Lovely work Max

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login

