What did you use your Leatherman for today?
-
Great use

-
@Philabuster said:
I needed to install some press fit bushings this morning. I used my ST200's awl to break up some dry ice to freeze the bushings, and then used the pliers to remove it from the dry ice and also to hold the cold bushing in place while I pressed it in the bore.Nice use!

-
last night, I gave my Surge a work out...well I got the workout but surge was holding up good.
A shaft for a chain curve was tangled up with plastic strapping...so I pull out the BO Surge. first used the serrated blade. Did pretty well. It was 2-3in thick of it so it was no picnic. Tried the saw. Also did decent. got tired of sawing away, so pulled out the pliers. I put all my weight into pulling the cutting up pieces (250+lbs) and the Surge held on tight!
Needless to say, I didnt get it all cleared out (limited access, barely enough for the pliers) but had a good time.

-
Sounds like you had fun :D
-
My work week has started!
On the label printer stacker (horizontal) the chute going up and placing the label was stuttering a bit. Took sides off, one which has belts, pulleys and electrical parts in the way.
Used my Rev to take out about 15 screws. Phillips was perfectly length and head size.
-
Great use of the Rev BM

-
Difficult task but the high quality bits did well

Sent from my POCOPHONE F1 using Tapatalk
-
Great use

-
It never ends


Sent from my POCOPHONE F1 using Tapatalk
-
@gregozedobe said:
Looks like that Charge is earning it's keep (and then some)
Actually I am already thinking of getting a surge to do all the nasty stuff at work and keep the charge plus tti for everyday carry.
The miniature size of pliers is the biggest factor to replace it, no need to mention the crimper part of the pliers which make it even more weak
Sent from my POCOPHONE F1 using Tapatalk
-
Great pics, Saridis
You will like a SURGE!!! for work I believe 
-
It’s a proper workhorse

-
Surge is a workhorse for sure

used my Sidekick to cut out a suction cup. Suction cup was partially ripped and needed replacing. I was a little impatient so I cut it off and replaced it

-

Moving around wall art in the salon. A bit of pliers, and shifting hangers.
But mostly used the Free P4 as a fidget device.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login


