Kent pattern axe mod
-
Well, I've got it as good as I can probably be bothered getting (this one), and I'm keen to apply the lessons learned to another one ::) (Got an old no-name hatchet laying around...)
On weighing the waste - I've just about halved the weight of the axe head, and though I have not had the opportunity to take any full swings, I used it to make some stakes and it work fine...admittedly, so would of almost anything else.
I am a little concerned with the area where I cut straight for the handle...there's what could be a bit of a stress point, but I'm not sure I can be bothered removing the handle to radius it. I guess I'll regret that when a crack forms....
I'm thinking for the next one I might take a lesson from your hard work and actually draw out and predrill the pattern, rather than just laying into it and hoping for the best 8)
-
My best suggestions would be to make a paper template of the axe then draw around pots an pans until you find what looks right
Cut it out and draw around it on to the axe
This way when your marks get rubbed off of the axe it's easy to re apply them
I now think that drilling holes might be a waste of time, it is probably easier just to cut it out with a hacksaw or a grinder

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login