Repair advice needed
-
Hi people. I have a CK pocket knife I bought in 1973 in the UK. I used it for 10 years or more. But the loop came detatched and I am at a loss as I don't know how these things go together. I was thinking that this might be a rivet within a hollow rivet. So drill out the old one and replace. Any advice would be welcome. Here is a couple of pictures of my old knife>


-
Can we have a look at the other side of the bail/loop and see how it's attached? My first thought is it might be possible to thin out the bail a touch and then re-peen the brass pin.
-
I don't think that's a hollow rivet, more likely a solid rivet with washers. Gareth's idea might work but I don't know how strong that would be. You would have to be careful not to over pean and tighten up that pivot too much as to make it a nail breaker.
-
As said, I too think Gareth's idea may work, given if you are really careful not not thin out the bail too much and there's enough material/rivet to hold the knife together.
Another approach I'd suggest to find the same diameter pin to punch out the old pin, then just re-peen both sides. For preventing it being too tight, I'd recommend check all the tools every (few) taps, and start slow. Alternate the chassis often when peening, and always use a anvil on the other side when peening.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
