The Tape Problem
-
Personally, I've found alcohol hand sanitizer to work quite well, I usually keep a 0.5oz/15ml bottle in my pocket.
-
Like others have already suggested, I too normally use wd40 or 3in1 as it's normally close to hand, but I find lighter fluid works best... not the gas though. If you want to be fancy try isopropanol.

-
I'm another acetone advocate, though lighter fluid can also work. Best tip, as others have already said, is to use the awl, it just doesn't seem to collect gunge like the blade does!
-
Orange. Simple! Use the knife to slit open an orange, and get the juice on the blade. It removes it like magic! Try IT ...
Aerojet
-
I learned this trick from other folks on a challenge--try using the awl instead of the knife, for box tape cutting. At least you don't have to clean it that often, and probably safer too.
-
Tape residue is a big part of the reason I love the Pioneer / Pioneer X, as the awl/reamer is perfect for opening boxes and avoiding gunk on your blade.
-
WD-40 is my way to go
Enviado de meu moto g(6) usando o Tapatalk
-
Isopropanol (99%)...
That’s what I use for cleaning, degreasing, sanitising etc.
De-cantered into small pump spray bottles.
Good stuff. But gone up in price from retailers and distributors since COVID. -
Another one for isopropyl alcohol. I usually use the alcohol prep pads when I'm at work. They're 70% and seem to take off all but the most stubborn tape gunk with just a couple of swipes. Make sure to clean your hands of all traces of it before handling the cellidor scales or you could leave partial fingerprints embedded in them.
-
Keeping tape residue off the blade is the job of the inline awl.
-
I use meths, works a treat (hic!)
Sent from my iPad using Tapatalk
-
Usually just use the thumb and finger wipe if it isn't too bad. I think the little bit of oil from the fingers helps. Have also used Eucalyptus Oil for removing stickers from things, or Citrus Oil works too. The oil helps to break down the sticky goop. Oil is good for getting sap and resin off your hands and garden tools
-
A lot of great suggestions here. Acetone, alcohol, WD40 and oil. I will experiment with each.
A couple of people mentioned using the awl to open boxed instead of the blade. Excellent idea.
-
@Ike582 said:
Tape residue is a big part of the reason I love the Pioneer / Pioneer X, as the awl/reamer is perfect for opening boxes and avoiding gunk on your blade.At last someone who shares my opinion for keeping tape glue out of the blade...

(BTW: beautiful worn looking Pioneer on your avatar mate ;))Why do people insist in using the blade for everything when they have a perfectly good and sharp awl readily available...?

As for chemicals, alcohol, etc, on celidor Saks.... Well you can use what you want, but me, I don't let alcohol or chemicals come with in a mile of my cellidor Saks, no matter how carefully one is, the scales will always get messed up, learned it the hard way.
For cellidor Saks, only warm water and soap, nothing else
-
@MacGyver said:
At last someone who shares my opinion for keeping tape glue out of the blade...
(BTW: beautiful worn looking Pioneer on your avatar mate ;))Why do people insist in using the blade for everything when they have a perfectly good and sharp awl readily available...?

As for chemicals, alcohol, etc, on celidor Saks.... Well you can use what you want, but me, I don't let alcohol or chemicals come with in a mile of my cellidor Saks, no matter how carefully one is, the scales will always get messed up, learned it the hard way.
For cellidor Saks, only warm water and soap, nothing else
Small blade for dirty, big for clean.
-
If you are careful maintaining an acute angle between blade and tape, you will get no gunk in the first place.
-
@MacGyver said:
At last someone who shares my opinion for keeping tape glue out of the blade...
(BTW: beautiful worn looking Pioneer on your avatar mate ;))Why do people insist in using the blade for everything when they have a perfectly good and sharp awl readily available...?

As for chemicals, alcohol, etc, on celidor Saks.... Well you can use what you want, but me, I don't let alcohol or chemicals come with in a mile of my cellidor Saks, no matter how carefully one is, the scales will always get messed up, learned it the hard way.
For cellidor Saks, only warm water and soap, nothing else
MacGyver is right as usual. I try to use the awl on my Tinker but when I do use the small blade I either use a thumb and finger wipe immediately and that usually does the trick. If you leave the residue on for a while then water and soap like MacGyver said is the best option.

-
The best substance to remove sticky gluey gunk from anything is Tea Tree Oil
Try it - You'll be amazed - And it is all natural ..... Probably won't even damage scales!
-
Another fan of WD40 or similar. Thanks for the other ideas y'all

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login