Show off your Sak mod's!
-
-
Thanks guys

-
-
I actually got explorers not only for the phillips, but the scissors too...

-
This not a mod, but an amateurish restoration... Helping a friend fix his Wenger SI that has a broken blade backspring...
The procedure is to replace the broken backspring without disassembling the entire SAK... just need to drill the center pin and push it out slowly with a new one... a simple but delicate procedure... and success... just need to peen it... pardon the crappy pick... my hands were shacking from excitement...
Am glad I kept all the nickle silver pins from the alox saks I took apart... I reused the center pin which came off a Pioneer X... Oh the backspring came from a Pioneer...

-
Good repair jaya_man

-
Again I know I have my own thread but I think this is another one people would be interested to see here (i.e. not just another spydernox :P). This one is based on a Victorinox Vagabond with added 91mm awl, eyeglass driver from a 65mm wenger, and orange peeler from a 74mm executive.

-
This is a funky ( in a good way ) SAK.

-
Wow - That is pretty amazing JS
-
Just counted up the original sources of these tools and there are five !!
Vic 58, 74, 91; Wenger 65; Spyderco (Ladybug?)Amazing !! ::)
-
MiniChamp with 91 awl

-
Nice

-
Hi All,
Here's my steel Pioneer. Hand made 2mm steel scales, hand made brass pivots, M2.5 torx screws. For the next one I'm going to peen then sand solid brass pivots :)
-
Very nice work!
-
Two blue Wengers:
- one is an attempt at putting saw, file, Phillips and scissors in the smallest package. I'm not sure I will use it a lot, as I miss the awl. I have a feeling that a 91mm with the same toolset will be better... if only I can find a 91mm combo tool.
- the other is a S557 without the pliers (I'm not a fan of SAK pliers in general, and while I can stand the Victorinox in a pinch I actively hate the Wenger "double hinge"). This one did see a little use, but has now been superseded by my Cadet X/Super Cadet/Alox Salesman.
And blue scales for both, obviously.
-
Good mods

To avoid stripping a 91mm Compact, the Combo tool from the much cheaper 84mm Waiter is a good alternative. Is a little smaller and needs a reprofile on the pivot to get it to seat a little higher when closed, but works fine.
I used to think SAK pliers were a wot too, until I started carrying my SC daily. Just the other day, a parking ticket slipped down the side of my seat in the car. Just a tip of the ticket was showing down in the seat mechanism...too small a gap for my fingers. The SC pliers were perfect to extract the ticket.
I see them more as super tweezers...
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login


