SAK Lanyard..?
-
They are nice.... I didn't relieve you of any bright cord sadly. Just got a nice bit of camo stuff so will make a few bits out of that soon.
For fob/lanyard purposes there's also cheaper cord like 250 breaking strain which is just fine.
-
Yeah, the yellow and black speckled stuff Ryan gave me is some kind of climbers cord. Not as strong if I remember Ryan right.
-
Cheers Gareth

-
-
Thanks but I have to admit that they are all done with just two knots:
http://en.wikipedia.org/wiki/Diamond_knot
This is the place to look for some impressive knot tying.

-
-
@Gareth said:
Yeah, the yellow and black speckled stuff Ryan gave me is some kind of climbers cord. Not as strong if I remember Ryan right.Climbing cord should be pretty strong, this page has a minimum breaking load value for various cord diameters, can't remember what size that stuff is though :-\ ::) 4 or 5mm i think. So theoretically it's stronger, but it will also behave differently under load as it's made in a different manner :)
-
Ooh, pretty colour ropes

-
This thread made me realise I did have that last little bit of the yellow kicking around to I made up my favourite simple fobs. Now nattily setting of the red on a tourist. :D

-
Lol - nice one Gareth. 8)
-
-
You can't beat a nice lanyard/diamond knot really, handsome and useful

I like a nice monkeys fist for that purpose too but the smaller ones are fiddly and I have to be in the mood to fiddle!
-
-
@Gareth said:
This thread made me realise I did have that last little bit of the yellow kicking around to I made up my favourite simple fobs. Now nattily setting of the red on a tourist. :D
Gareth, Did you burn those ends with a regulear lighter or is there some trick avoiding them getting black...?

I'm quite sure I got the knot right now, so it's time to get a little further... -
Those I did on a gas cooker. I used to use a Zippo/Clipper/Bic lighter but I suspect that a lot of the discolouration comes from the quite dirty, yellow flame that they produce. My thought is to try and use the cleanest bluest flame you can.
-
@Gareth said:
Those I did on a gas cooker. I used to use a Zippo/Clipper/Bic lighter but I suspect that a lot of the discolouration comes from the quite dirty, yellow flame that they produce. My thought is to try and use the cleanest bluest flame you can.Hmmm... Might be a revival of my Zippo BLU lighter... :D
-
Has anyone tried non flame based heat sources, like an electric hob for example? That could give a very clean paracord melt.
-
If it's not a loose end then I melt it with a hot knife blade. So, as you can see on the first two, after I trim the ends flush to the fob I heat an old SAK blade and use it to seal the cut cord. It's just a way of not melting the areas you don't wan't to. The far right one you can see that I used an open flame and melted the cord next to the bit I was trying to seal.

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login


