What did you use your Leatherman for today?
-
Great use, GF
I have done this before with the duct tape and the nail as well
anytime you can carry duct tape easily and in a very small space is always a win 
-
Did some carving.


-
Built a small shelf today. Used the Surge's file to clean up edges, the large flat screw driver opened a can of wood stain, and the pliers were used to hold a piece of pvc while heating it over a torch (then formed into a 90° bracket, used to secure the shelf to the wall).



-
PST helped me with some hot stuff. I swapped some joysticks on a controller. Things get damn hot


-
Use my Rebar and a couple of paper clips to make a hook for my no touch tool (trying to up my EDC sleeping area). Just need to wide the hook a little and retie the lanyard since the one it shipped on untied.


-
Used my sidekick to loosen and tighten tiny nuts. Between the Sidekick and 4" adjustable, got it all tightened.
Swapped out a sensor on the flat sorter

-
Same reason I carry a SC and Knipex, gives me two tiny bionic grippers 👍
-
The Knifeless helped open the packaging for new storage equipment.


-
Used the PST to breake some Aluminium pads from a pc cooler and make them into heatsinks

-
The good
Spoiler:
We spent some amazing time in the woods gathering mushrooms yesterday. I used Work Champ and handed a LM Signal with a brand new never used before factory sharped blade to my lady


Also used scissors to open a new pack of zesty Carpathian herbal tea [emoji478]

The bad
Spoiler:
After cutting a few shrooms the blade on a Work Champ stopped being shaving sharp - fixed really quick today, but to me shrooms are a pretty soft substance that shouldn’t affect sharpness that fast
The ugly
Spoiler:
It was a rainy day, so i just wiped both blades with my sweatshirt and put back in their sheaths.
Today I’ve also discovered some rust stains on a Signal blade [emoji17]
Cleaned easily with Ballistol and a piece of cloth, still I find it pretty disappointing


-
Mowed the lawn for the last time this year, so decommissioned the lawn mower. Drained the gas and pulled the carb. Scraped out built up grass from the underside too.


-
Used my freshly out of warranty (they sent me a new one because they don't do repairs in my country) wave plus to temporarily fix its sheat.
Had it for a year and a half and the velcro from the lid was damaging the part under the tape, which I think would've lead to a hole.So I burnt the fiber that was going wild, cut up the burnt bundles and then applied some electrical tape to prevent it from happening again.
I know this isn't going to last but I've been playing with it a lot since I got it back so I didn't want to tear a hole in it until I find a more permanent solution, or until I can justify the money for a new sheat.
:D
-
Used the Squirt to cut a cable, to change the polarity in order to be able to play the GB from a powerbank.

-
Used Surge scissors to cut a chip bag in half. Makes a nice bowl.

-
I used the tweezers on the Free T4 to pluck out a leaf fragment which was stuck in my flashlight's pocket clip.
-
A most boring and menial act, but it saved me an hour of frustration. Clearing a paper jam with my Rebar pliers. I could barely grasp the paper with my finger tips so the pliers was able to grip it by a few millimeters and I slowly pulled it out.
I always said I can make do with a Cadet. I change my mind. Long live the Rebar!!!!
-
Today i used the free p4 for a bit finger Training;
Dit someone notice this thing even got a one hand plier??
Its fun to open and close the pliers whit one hand, although it may get a bit dangourous because the sharp tool oposide of the Main Blade handle half sometimes swing out a bit.. ^^
Nice tool, and fun to use -
The Juice KF4 and the UTA helped straighten out the basket on the bike. Those two make a very capable package together.

-
Used my Surge's large flathead to scrap a label stuck on a conveyor roller. Worked great. Sprayed simple green on it to remove the stickiness. 2 thumbs up :ahhh
-
@nitram said:
The Juice KF4 and the UTA helped straighten out the basket on the bike. Those two make a very capable package together.Those UTAs are a great accessory for a multitool. I'm surprised LM didn't sell more of them (based on how few I see for sale - or maybe current owners like them so much they refuse to part with them).
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login