CyberTool owners thread
-
@SirVicaLot said:
Love it. Already tested the screwdriver, and it is sturdier than I expected. It will do fine for my uses
I felt at least partially responsible for you ordering one based on discussions in the “What SAK surprised you most?” thread, so I’m glad to hear it is meeting expectations!”
-
@nate j said:
I felt at least partially responsible for you ordering one based on discussions in the “What SAK surprised you most?” thread, so I’m glad to hear it is meeting expectations!”Bunch of enablers, all of you :D
I really like it. For the time being, it kicked the Handyman off my EDC tray

-
He-he-he, you’re welcome!
Glad you like it! 
-
@pa_strunk, very nice job!

Congratulations Sir Vic. Any plans for modding it? (Sorry, couldn't resist 😉)
-
Indeed - I moved the tools around a little on my CT34 (started out as a CT lite) to put the bit holder in the middle.

-
@Dutch_Tooler said:
@pa_strunk, very nice job!
Congratulations Sir Vic. Any plans for modding it? (Sorry, couldn't resist 😉)
No need, I like it the way it is. Doesn't bother me that the screwdriver is not centered. It makes it easier to use in some areas. You can't turn the SAK completely, but it still allows you to turn the screws by turning the SAK halfway, and then resetting it. Not doable if the screwdriver is centered.
-
Ordered some additional 4mm bits. You can never have enough bits :D
They of course don't have the retention ball, so I think I will need a small magnet to fit into the bit holder. Any recommendations?
-
Found a pretty neat solution online to use regular 4mm bits (without the retention ball) with the Cybertool:



A piece of shrink tube over the bit holder supplies enough retention to prevent the non-Vic bits from falling out. It also doesn’t hinder the use of the original bits in the slightest.
-
Good idea!

-
That's clever!
-

Could have saved me from the mess I did when I glued in the magnet into mine.
-
@SirVicaLot said:
Found a pretty neat solution online to use regular 4mm bits (without the retention ball) with the Cybertool:


A piece of shrink tube over the bit holder supplies enough retention to prevent the non-Vic bits from falling out. It also doesn’t hinder the use of the original bits in the slightest.

Thanks for sharing!

-
Could have saved me from the mess I did when I glued in the magnet into mine.
You can use this trick to hide the mess, now...

-
@pfrsantos said:
hide the mess, now...
-
@pfrsantos said:
You can use this trick to hide the mess, now...

No need to!
I "dismessed" it the next day after I was able to separate my fingers again. -
@McStitchy said:
No need to!
I "dismessed" it the next day after I was able to separate my fingers again.
:D :D
-
Hmmm I've seen that gif before

-
You guys are killing me

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
