What did you use your Sak on today?
-
Using it for what it wasn't designed for( again ) :D
Small flat driver turning square drive screws
-
Unfortunately I ended up cutting the one piece to short, so rather then waiting it I figured why not just make one without the flap? So that’s getting glued, but as of now I had to use the FarmerX again and put it back in the press for round #2 for making another front, already made another back with the flap, made it about another 3/4” longer too just in case,, so here’s the sak at work getting pressed with leather,, again..
JROh and the original where I cut the front too short where the flap wouldn’t reach, so it got cut to make just a simple pancake,,



-
Update,,
I finally got time, so I carefully lined everything up and checked it about three more times then cut it to fit,, and there it is.. I then roughed up the backside of each piece and lathered them up with glue, made sure everything’s good about three times and then put it in the press! So it will sit till tomorrow or the next day,
I also took the one I screwed up on and smoothed out the sides and cut the belt holes, so not that’s ready for the stitching..
JR

-
Strangely, I used my Farmer for a keyring. Look closely at the bottom of the sawmill control panel, and you will find that I now have a Farmer for a keyring for the sawmill.
.jpg)
-
And as I always says,
If you has a keys,
You needs alox to goes with it.
-
True words, Jim! I like your new sheath, MadPlumbarian - great work!

-
So today the Ranger's scissors got to do some "pinch-hitting."
I'm always fouling up the black plastic strapping when I strap the lumber stacks together. I use the scissors rather than a knife blade to clip the strapping when I want to reuse it. When hyperstressed, the strapping splits. I have to clip it back beyond the split and splice it with a clip. I find the scissors work better than a knife blade when you want a clean solid remnant that is strong enough to splice. The knife can exacerbate the split or start a new one, potentially. Scissors seem to make a more professional edge. (or maybe I just imagine it). ???
Oh, btw, 5 points to whomever can guess or figure out what kind of wood the strapping and Ranger are resting on.....

-
No real use of the Vic in general but I think it´s ok.
I am working in a mechanical workshop and everybody has gotten a Victorinox Alox Electrician.
Today my workmate wants to cut a pice of rope, but unfortunately it was a wire rope with fabric sheathing.
So it was time to give the blade a little sharpening service.
I took two pictures before and two pictures after sharpening the blade.Nice Weekend to all of you.





-
@Masel said:
No real use of the Vic in general but I think it´s ok.
I am working in a mechanical workshop and everybody has gotten a Victorinox Alox Electrician.
Today my workmate wants to cut a pice of rope, but unfortunately it was a wire rope with fabric sheathing.
So it was time to give the blade a little sharpening service.
I took two pictures before and two pictures after sharpening the blade.Nice Weekend to all of you.

Nice edge!

-
Used a Florist knife to trim some flower stems. Just to prove how manly I am.

-
Used Vix Work Champ and a LM Signal to make a power extension cord.
Of course, it all starts with that beloved long Phillips for the outlet disassembly

Than a knife and a cap lifter for stripping those wires

Then pliers for crimping

Phillips again to put those wires in place

I needed to cut the wire, so Signal wire cutters came in handy. Did the job, but the wire slipped out of them due to it’s thickness

Here’s the final result

-
Great use alexanderre! That 111mm small Phillips is an excellent tool.
-
The time has come to replace the car key battery. Used a cap lifter to open up the enclosure [emoji1305]


-
I used my scissors quite a bit today. As usual at work, I now use my Farmer as my keyring for the sawmill. (Among other things).
-
Spirit was used to install a smoke detector in my office.
My SAK collection feels safe now. -
Thank you :)
-
Used the ones in the picture for a small video to tell how the Offiziersmesser stands as foundation for the current models. Also i used the file and nail cleaner from the SD

-
Not me but the kid used my sak to open his package that came in, he was so thrilled!

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login