Screwdrivers?
-
Did somebody say EASYDRIVER?
-
Got these little gems in an old machinists' tool box I bought several years ago.Some are marked Blue Point(a Snap-On secondary brand)and others are unmarked.The two that are made of nylon I believe are used while working on electrical components.The smaller one is marked,"Aircraft Spec".
To remove a screw,you turn the shaft while holding the end and this aligns the small section in the middle of the tip with the screw slot.Press onto the screw and start to loosen(counterclockwise)and the spring loaded center part of the tip locks the driver onto the screw.
To install a screw,fit the tip into the slot and turn the handle again counterclockwise which engages the center of the tip with the slot;holding the screw. Insert the screw into the hole and start to tighten(clockwise)and the spring loaded center aligns with the slot and releases from the head. Great for working with non-magnetic stainless steel screws.


-
Here is the other picture of the tip in the unlocked position.

-
Lately I've been carrying the Chapman 2021 pocket screwdriver set. Very impressive!
-
Yes those are screw starters I still have two back in the day I used them when installing points in older cars.
Mike
-
@Mike 56 said:
Yes those are screw starters I still have two back in the day I used them when installing points in older cars.Mike
Thanks for the clarification;I'll have to see if they work on my car the next time I put points in it.I usually take the distributor out when I do that as it is easier to work on that way.
-
My dad was a mechanic back in the 1960s my dad taught me how to do tune ups he showed me using screw a starter for the point and condenser screws. If drop a screw in the distributor it can be a real pain to get it out.
Mike
-
@Mike 56 said:
Yes those are screw starters I still have two back in the day I used them when installing points in older cars.Mike
They are also invaluable when working on electronics when you dont want to drop a stubborn screw in the wrong place and when trying to get screws started really anywhere and dont want to have to try 100 times,resetting the screw on the driver every single try!
-
@Ray S said:
Got these little gems in an old machinists' tool box I bought several years ago.Some are marked Blue Point(a Snap-On secondary brand)and others are unmarked.The two that are made of nylon I believe are used while working on electrical components.The smaller one is marked,"Aircraft Spec".
To remove a screw,you turn the shaft while holding the end and this aligns the small section in the middle of the tip with the screw slot.Press onto the screw and start to loosen(counterclockwise)and the spring loaded center part of the tip locks the driver onto the screw.
To install a screw,fit the tip into the slot and turn the handle again counterclockwise which engages the center of the tip with the slot;holding the screw. Insert the screw into the hole and start to tighten(clockwise)and the spring loaded center aligns with the slot and releases from the head. Great for working with non-magnetic stainless steel screws.I've read this before, a few times. Only today did I understand how it works.

Cool tool! I'm still looking for an angled screwdriver, since I saw it here. Looks great, too! Thanks for sharing this, guys!
-
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login