Do most knives need points?
-
A possible "worst of both worlds" options might be a "full size" spey blade (not sure how many are on the market as solo folders)
predominately flat edge, short sharp curve to the belly, and a not pointed and not flat tip.
Whatever camp you're in, it's sure to have something to offend you ::)
Not exactly what I had in mind, but I was curious if any "tactical" blade marques used the style...the closest I found without much effort was these two by CRKT
https://www.crkt.com/shop/everyday-carry-knives/radic.html
https://www.crkt.com/shop/everyday-carry-knives/montosa.html -
You don't awlways have a tooth pick at hand or some piece of wood you can make one out of.
Next question.

-
There are IMO 2 reasons to not have a point
- If your knife is intended for prying (see border-guard dagger attached)
- Avoid accidental stabbing (often seen in sailor knives, knives for children and rescue blades)
Since I try to avoid prying with my knife, and I'm neither a child nor a sailor I prefer having a point as it has so much utility.

-

Just wanted to say...I see your point!
-
Having pointy and less pointy I concur.
-
@gregozedobe said:
If the cutting surface is completely flat then when I am cutting on a hard surface with most knives I often end up doing a lot of cutting on the very tip (or mashing my knuckles on the hard surface), rather than spreading the cutting along more of the edge. If the blade is very deep (top to bottom) it works OK, but most of the knives I use are not.One time I do use the pointy tip is to start a cut to get through the hard outer skin of a passionfruit, just slicing doesn't seem to work as well.
Gentlemen, ladies, et al., of the jury, these seem like valid evidence.
-
@cody6268 said:
Sheepsfoot/Lambsfoot for the win. You have a blade that is impossible to accidentally poke something, while still having a point when you need it. I don't like any belly at all in a one-bladed knife, so they are my favorite blade style.I have had blunt and completely rounded tip knives, both SAKs intended for kids, and knives intended for paramedics to quickly remove heavily clothing, and they were horrible for EDC use.
Deduction: Since my coping blade meets my edc needs and square Enders have abysmally failed to meet yours, our opportunity set of cutting must vary.
For what it is worth, I have carried a Case swayback wharncliffe pattern and found it so pointed as to offer nearly the same accidental puncturing as clips, etc., while working, plus the wharnie spine curvature just seemed guarantied to make it fold on to my fingers when used with a stabbing motion. I like the look of wharnies but need a lock to enjoy them.
-
This discussion shows how different requirements lead to different solutions. None are "wrong" in any objective sense. ETTO and all that yet again....

-
@nate j said:
I think the ideal thing is to carry several different knives, or one knife with multiple blades, so that all bases are covered. However, if I had to pick just one, I feel a pointy knife is more versatile than a non-pointy knife. The point comes in handy for things like splinters (as Steve pointed out), and also for making the initial penetrating cut on everything from fruit (as Greg noted) to blister or vacuum packs. A pointed knife is also better for sliding the point under something that is cinched or tied tightly (cable ties, rope, paracord, string, hospital or carnival bracelets, etc.) and cutting it off without damaging what it is tied to or cinched around.Personally, all other things being equal, I believe a blade with a curved cutting edge is more effective at the efficient draw cut than a blade with a straight cutting edge.
Finally, I note that even coping blades and sheepsfoot blades have points, thought they are typically less acute than those found on clip, spear, and drop point blades.
I agree, if I need both EDC cutting and tactical/game cleaning, but I just don’t use the belly except in a kitchen. And anyone can snag a dozen varieties of kitchen knives superior to a pocket knife for kitchen use at a dollar a knife.
-
@Etherealicer said:
There are IMO 2 reasons to not have a point- If your knife is intended for prying (see border-guard dagger attached)
- Avoid accidental stabbing (often seen in sailor knives, knives for children and rescue blades)
Since I try to avoid prying with my knife, and I'm neither a child nor a sailor I prefer having a point as it has so much utility.
Could you be specific about the abundant uses of the point. I am not sceptical. I am trying to get the uses of knife points inventoried.
-
:D
Different blades for different jobs.
-
@SgtTowser said:
And anyone can snag a dozen varieties of kitchen knives superior to a pocket knife for kitchen use at a dollar a knife.That is true. Personally, though, using pocket knives on food isn't something I generally do in my own kitchen. Rather, it is something I do when I'm out and about, hiking, camping, at fairs or festivals, etc., and in those cases it is much more convenient for me to be carrying a pocket knife that also works for food than to also carry a dedicated kitchen/food knife.
-
@SgtTowser said:
Could you be specific about the abundant uses of the point. I am not sceptical. I am trying to get the uses of knife points inventoried.- Fine tip used to slide into the lock of a zip-tie
- when your knife is not that sharp anymore it is great to start a cut, e.g. cut a tomato while hiking and not wanting to eat ketchup.
- pinch the blade at the tip to open packages without cutting deep. While you can do it with the edge, it is much easier to restrict the depth by pinching the tip.
- use as "awl"
- puncture stuff (e.g. juice box, so that there is air going in when the straw seals too tight)
- papercrafting
-
Funnily enough, I just thought about this not even an hour ago, in the kitchen. I've been a spear point fan for years, but also being a slipjoint fan, I never stab into anything. Even my folding hunter is a drop point, and not very stabby.
Enter, my kitchen....
Meet the characters -
New box of pasta.
Opinel No.10 Locked open at the readyTo open the pasta, I just stabbed the clip point straight through the top of the box and chopped it off like a pirate or something. it was fun and efficient.
I immediately looked to see if the locking EvoGrip in yellow comes with a corkcrew on the Victorinox website

-
@cody6268 said:
Sheepsfoot/Lambsfoot for the win. You have a blade that is impossible to accidentally poke something, while still having a point when you need it. I don't like any belly at all in a one-bladed knife, so they are my favorite blade style.I have had blunt and completely rounded tip knives, both SAKs intended for kids, and knives intended for paramedics to quickly remove heavily clothing, and they were horrible for EDC use.
THIS!!!
My two favorite pocket knives don't have a pointy blade. My Christy knife that is a modified wharcliff, and my Victorinox florist knife, also called a garden knife. Man years ago when I had a Buck 301 stockman that was my main EDC for 25 years, the most used blade was the shepfoot. Way way back, I carried a Camillus rigging/sailor knife with one heavy duty sheep foot blade and a marlin spike. That shepfoot blade did everything needed.
Look at the worlds most heavy used knife on any construction site, home improvement site, industrial plant; the old Stanley 99 and whatever knock offs there are. That little one inch slanty sheep foot blade does more work world wide than any other blade style.
-
@cody6268 said:
Sheepsfoot/Lambsfoot for the win. You have a blade that is impossible to accidentally poke something, while still having a point when you need it. I don't like any belly at all in a one-bladed knife, so they are my favorite blade style.I have had blunt and completely rounded tip knives, both SAKs intended for kids, and knives intended for paramedics to quickly remove heavily clothing, and they were horrible for EDC use.
@gregozedobe said:
I agree that I don't use the point to stab anything very often, but I prefer the curved edge leading to the point. If the cutting surface is completely flat then when I am cutting on a hard surface with most knives I often end up doing a lot of cutting on the very tip (or mashing my knuckles on the hard surface), rather than spreading the cutting along more of the edge. If the blade is very deep (top to bottom) it works OK, but most of the knives I use are not.One time I do use the pointy tip is to start a cut to get through the hard outer skin of a passionfruit, just slicing doesn't seem to work as well.
Maybe 20 years ago, I bought a couple of junky wharncliffe blades, since the most important what-if scenario in my mind was "rescue". As mentioned, these were complete rubbish for EDC. Then for a couple of years I carried a tanto point blade, thinking that the flat edge could be used to tighten screws (spoiler alert - it couldn't because it would cam out right away). The lack of a belly on this style of knife is what made it quite useless for EDC,
I swore off anything except for a drop point or spear point, after realizing I prefer my drop point folding hunter over the clip point.
I got a Gerber with a sheepfoot blade last week... and I'm still
about how I talked myself into that. -

For me, a sheepsfoot blade is almost ideal for EDC. But that is due to my most frequent use for a knife: stripping the outer sheath off of non-metallic cable (Romex, SE cable). A pronounced belly is a hinderance. I was very excited when I saw the blade above, and I keep reaching for that MT seen above every few days due to that blade's utility to me.
However, I do wish there was a drop point blade paired with the sheepsfoot. A point comes in handy sometimes.
-
- Fine tip used to slide into the lock of a zip-tie
- when your knife is not that sharp anymore it is great to start a cut, e.g. cut a tomato while hiking and not wanting to eat ketchup.
- pinch the blade at the tip to open packages without cutting deep. While you can do it with the edge, it is much easier to restrict the depth by pinching the tip.
- use as "awl"
- puncture stuff (e.g. juice box, so that there is air going in when the straw seals too tight)
- papercrafting
Interesting list. Thank you for taking the time.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login