Versatile and small outdoor stove
-
Today I brewed up some hot water for coffee using the Nano as a stand for a Trangia.

Worked pretty well, but was slow, as alcohol stoves can be. Wind was again an issue. I think next trial will be with the Trangia resting on the floor plate, perhaps a bit better protected from the wind. It is very nice to be able to just drop the Trangia onto the support pins, but it raises the fire ring up where the Nano isn't able to shield it very much.
More experimenting indicated...... :D
-
Awesome review Nix. Your observations are right on with what I have observed, especially the larger than seem necessary bottom plate holes and the wind impact.
I am glad that you seem to like it and can see some use for it. I look forward to reading your impressions as you use it more.
-
More testing and training today ( making a coffee was the ever-handy excuse.... ;) ).
I needed a coffee.....
I thought I'd try out an Esbit fuel block to see how it would do in the stove. Firebox sells a dedicated Esbit tray that can rest on the struts ( "Nano pins" ) used for the Trangia. ( @Sos: do you have one of these trays? ) I thought I'd use my improvised mesh panel with an Esbit. The idea here is that the tray, or, in my case, mesh panel raises the Esbit up to be closer to the cook pot and improve efficiency.

My set up included my Mk II windscreen--it was another windy day. I also added a few twigs. This is something I do even with the standard Esbit stove. It adds a few extra BTU's and helps create a visual indicator that the fuel is burning.
I used a.....22 oz (?) titanium mug filled with 14oz of cold water. I used a homemade lid that has suffered over time and doesn't fit snuggly. But it is a lid. As noted I used one (1) Esbit cube and a few twigs ( just those pictured in the photo above, no more were added. ). It was 70ºF (21ºC) with light to moderate winds.
Stove running:

You can see the Esbit block is fairly close to the pot. Once the sticks burnt down, the block settled down a couple of millimeters.
In addition to serving as a wind block, the Mk II screen also reflects some heat back and make the stove more efficient.
The water slowly heated up, but by the time all the fuel was consumed, the water had just come to a boil. It was not a rolling boil, but a nice noisy simmering boil. 100% fuel consumption.
The coffee was good and hot. :D
This result seems pretty consistent with my other experiences with Esbit blocks: I've found 14oz is about the maximum amount of water one block can boil at this altitude (5000'). I was wondering if the open mesh would increase the burn rate and change the burn time & efficiency of the Hexamine cubes, but I'm not sure I noticed a difference.
I didn't time this trial...soooo......more testing is indicated......

-
I've found another thing to like about this stove: once it has finished burning, it cools down fairly quickly. Before I was done my coffee, the stove was packed up and ready for the trail.

-
I have the Esbit tray and the flame guard (slide on top side to help protect pot/cup handles. They both fit in the x-case but it doesn’t snap shut as well with the carbon cloth.
The solid fuel tray just sits on top of the pins like you mention and is solid. It works pretty well, but I’m not sure how much better it would be than your set-up.
I’ll get a picture shortly.
The cooling off quick is something I really like too.
-
@Sos24 said:
I have the Esbit tray and the flame guard (slide on top side to help protect pot/cup handles. They both fit in the x-case but it doesn’t snap shut as well with the carbon cloth.The solid fuel tray just sits on top of the pins like you mention and is solid. It works pretty well, but I’m not sure how much better it would be than your set-up.
I’ll get a picture shortly.
The cooling off quick is something I really like too.
Here is a picture of the Nano with the solid fuel tray

-
@Nix said:
More testing and training today ( making a coffee was the ever-handy excuse.... ;) ).I needed a coffee.....
I didn't time this trial...soooo......more testing is indicated......

You better be careful with all this “testing”. That is where it started for me. Now it is a weekly (at least) habit.
-
Awesome review Nix.

Given how little I use the multitude of stoves I already have I really don't need another one...but I'm still very tempted. :D
-
More testing and training....... Will this testing never end?!

A hot day. Seemed like a good idea to cook outside......which meant there was a need for the Nano.
Here was my set up:

• 6" cast iron skillet
• Firebox Nano
• Firewood ( twigs and splits and such )
• FireNaturally, the wind picked up about 12 seconds after I got the stove going. While the wind acted like a bellows and really pumped up the fire, it also blew the heat sideways, less upwards.
Despite that, my little skillet got hot enough to drop some butter in with a gratifying sizzle. Once that had stopped bubbling away, in went a couple of seasoned pork chops.
Total success!
However, there were some lessons learned:
-
The wind will awl-ways pick up when you light the fire. Plan for a windbreak.
-
The Nano is light. While moving the heavy skillet around ( to pull the handle from the downwind position to a safer spot ) and flipping the chops, the Nano tended to skate on the hard paver. In hindsight, the carry case would be a good idea to stabilize the Nano when on smooth or relatively slick surfaces.
-
After I flipped the chops, the fire calmed down a bit. I think I had overcrowded the pan, as well. As a result, the second side didn't sizzle and sear quite as well. This wasn't a big problem, but the second side did take a bit longer to cook. I added some more fuel to get the heat going, which seemed to help.
-
When adding long stick through the feeding ports, coals sometimes got knocked out of the other port. I started using one stick to hold coals in the Firebox while feeding a longer stick in the other. This seemed to help that issue, but I still had a few coals fall out as the fire burned down and coals settled. Fire safety continues to be important.
-
When using cast iron, get the pan good and hot before cooking. My butter was sizzling away, but I think I could have gotten the pan a bit hotter. Cast holds heat really well, but in my experience thoroughly pre-heating cast iron is very helpful. So, more time on the stove before adding ingredients. And don't crowd the pan.
Awl in awl, I had a lot of fun using the Nano and skillet as a combination. No residences were burnt down and the chops were cooked to perfection. ( Still a blush of rose in the center. )
Now I'll be forced to test other pans......

-
-
One semi-clever thing I did when making my pork chops was having a metal bucket at the ready while using the Nano.
After the chops were done, but before going inside with them, I tossed the buck over the fire to make it safe while unmonitored.
This is useful at home. In the woods, I expect I'll sit with the stove until it is cold.

-
Those look awesome. I’m really glad it worked for you. The x-case does prevent the stove from moving around some, but because it is so small and light it can move.
I frequently use a stick to push in or block burning embers/ash. the Nano’s firebox being so small, it does take some careful maneuvering with larger sticks. I find myself breaking sticks and feeding in between the stove top and pan more than the feed holes when using smaller pots. I also find if possible pushing the stick in at a slightly upward angle can decrease the likelihood of pushing embers out.
Happy testing. I warned you it is addictive.
-
:D
I did some top loading as well. The Nano does make it pretty easy to get fuel into the burn box. I can see there is a little skill set to develop with this stove...but that seems like fun, too. :D
Yes....more testing and training..... **** sigh ****
-
Another grueling day of testing and training.....
Here was today's test set up:

• Nano case
• Nano with Trangia pins
• Trangia
• 10" aluminum pan
• pot grabber to manipulate pan
• Lucky Phillies garden gnomeThis pan is from Firebox and is anodized. However, they give directions for 'seasoning' the pan like one would a cast iron pan. I duly seasoned the pan and have been using it a bit on the range. It works very nicely and I haven't had any sticking issues yet.
But...it is meant to be used for camping...so I wanted to test it out on the Nano.
I had some reservations about putting a 10" pan on a little Nano; however, with the supports angled outward, and secured in the case, the pan felt solidly planted on the stove. The fact that the pan has no handle also means it doesn't have a heavy lever trying to tip it over. Very clever Firebox!
It was a calm morning, so I didn't use the windscreen.
Of course, as soon as I lighted the Trangia the wind started up. And I do mean the wind picked up the very instant I lighted the stove. I felt the Lucky Phillies Gnome was letting the side down.....
Today's trial included breakfast:

( You can see that I set up my Mk II wind break after the wind picked up. )
My apologies to those of you who may be cardiologists.
Breakfast was eggs and scrapple* fried in French-levels of butter. I find that ample use of butter greatly enhance the non-stick qualities of cast iron and other cookware.
Having learned from previous experience, I made sure to use the pot gripper to gently lift the pan slightly off the stove wen flipping or turning. This worked very well.
To wrap up, the eggs were placed on top of the scrapple and eaten with knife and fork. Mine got well dosed with some Texas Pete hot sauce; Mrs Nix went for ketchup. Putting the egg & scrapple on bread and making a sandwich--sometimes called a "Scrapple Banjo"--works well, too. But we didn't have bread. :-\
- Scrapple is a German-American specialty. It is a kind of sausage composed of all the parts of the pig that aren't fit for hot dogs, usually with some heart and liver. I make my own in the Fall, but this was store bought stuff. Not bad, if perhaps a bit heavy on the corn meal. Scrapple is analogous to Cajun Boudin Blanc, but made with corn meal instead of rice. It is delicious when fried up crispy. :D
-
Great Post!!! Looks good!!
-
Must be hard to do all this testing Nix, and probably not fun at all

Sent fra min M2002J9G via Tapatalk
-
Much appreciated, wouldn't want to get outside and play with fire(not jealous at all FYI!)

Sent fra min M2002J9G via Tapatalk
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login


