Leatherman Bond Owners Club
-
I swear it is either my fingers have a mind of their own...or evil autocorrect has now invaded.

-
I swapped the file for a Rebar saw.
I tell you what, those anti-tampering screws were difficult to remove, even with the special wrenches from loki. Not only were they super tight, but the partially raised handle surrounding half of each screw basically acts like ramp to lift the wrench off of the screw head. A socketed version of the wrench would have been ideal for this particular tool.

-
Nice !

-
Great mod, hsherz

The Rebar fasteners are similar and are a bit difficult sometimes as well

-
@Poncho65 said:
Great mod, hsherz
The Rebar fasteners are similar and are a bit difficult sometimes as well

Thank you! I suspected as much regarding the Rebar, since the handle geometry appears so similar. But since the Bond and Rebar are so similar, the saw fits like the proverbial glove. The only modification that I made was to glue a sliver of plastic inside the handle to prevent the teeth at the tip of the saw blade from dulling themselves on the metal. It also made the saw blade easier to open.

-
@hsherzfeld said:
I tell you what, those anti-tampering screws were difficult to remove, even with the special wrenches from loki. Not only were they super tight, but the partially raised handle surrounding half of each screw basically acts like ramp to lift the wrench off of the screw head. A socketed version of the wrench would have been ideal for this particular tool.Did you heat the pivots first?
-
@hsherzfeld said:
To free the screws from the loctite, you mean? No, that never occurred to me.
I don't have an easy way to do that, anyway.Yes. I think most folks use a lighter.
Most of us use a lesser strength of Loctite than Leatherman does when reassembling. -
@hsherzfeld said:
To free the screws from the loctite, you mean? No, that never occurred to me.
I don't have an easy way to do that, anyway.I use a candle, holding the tool about an inch above the top of the visible flame, and heat each side of the pivot about 10-20 seconds at a time. Really stuck pivots can take a minute or more of heating to loosen. Even once you've broken the epoxy, it'll still partially stiffen when it cools, so unfortunately it's easiest to work with while uncomfortably hot. Try not to burn yourself too much.
-
I got one , bought it very cheap


-
Congrats, Ivo

-
Nice !

-
No it was the only one

-
Great pic, Steve

-
Thanks !

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login








