Charge Owners club !
-
Love the combo today, Steve

I will get back to something like that next month

-
The Charge drawer.
20210615_124518A by Chako, on Flickr -
@Chako said:
The Charge drawer.
20210615_124518A by Chako, on Flickr
I have only one charge, found it a few weeks ago 

-
My latest edc, retired my 2nd Gen TTi for this beauty.

Sent from my SM-G980F using Tapatalk
-
Finally found one of my grail Charge's, No. 0185/1000.


Sent from my SM-G980F using Tapatalk
-
@Hood3dvillain said:
Finally found one of my grail Charge's, No. 0185/1000.

Sent from my SM-G980F using Tapatalk
very nice 
-
Sweet pics Ivo and Hood :o

Love the Anniversary edition, Hood :ahhh :ahhh :ahhh

-
OG Charge :P



-
Why must you torment me so :ahhh :ahhh :ahhh

-
The Charge is the multitool I like the best. However I have this problem with the scissors, the spring snaps out of position after only a few snipps. It has been like this ever since it was new.

-
Hello Niro,
I had a similar problem. It seems to mostly relate to this 'meshing' of the spring lever tip against the lever. As the metal is stamped to shape, the surfacing is often not smooth and the spring tip can be dislodged as it rides against the lever.
I would suggest filing carefully to ensure the lever is smooth where the tip rides on the surface, and even create a slight 'undercut' to help keep the tip from hopping out.
Also check the main scissor blade (the one that pivots off the body) is 100% straight, and not diverging away from the spring lever.


-
That happens with a few of mine as well
I do actually have a couple that don't do that and I hvae no idea what the difference is
I do wish they would revamp or redisgn these and tweak them a bit because I always end up carrying a SAK with scissors because the LM scissors aren't as good :ahhh -
I see that Max has thought of a reason for this to be like that
I may give that a go and see if it helps any of mine 
-
My problem is a gap between the siccors and the spring. If I dismantle the tool and bend the two pieces closer tighter it will probably be just fine.

-
Mine usually only springs apart when I cut something that is a bit tougher, paper and the like is usually fine 
-
@Niro said:
My problem is a gap between the siccors and the spring. If I dismantle the tool and bend the two pieces closer tighter it will probably be just fine.If you look closely, the spring is straight, but the scissors are bent in a bow. They should only bend inwards slightly after the pivot point of the scissors. (1mm at the tip).
But you are right - it will need disassembly to properly correct.


-
@Poncho65 said:
Mine usually only springs apart when I cut something that is a bit tougher, paper and the like is usually fine 
It's not a great design as only a little sideways pressure of the scissor blades when cutting causes the lever to pop out. It needs to be captured on the tip like Vic has done since 1990 with the groove on the underside of theirs. But I suspect it's too much of an engineering change for LM to adjust for this (minor?) design flaw. 
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login