June Pocket Rocket Challenge
-
@Rizio Il Ghiro said:
an eBay snagged Casio fx115d which needs to have horribly gooey old feet removing from itVery nice. I've really enjoyed the calculators in this challenge. Takes me back. I wish I had more of a need for one now, but I don't do much that requires a brain, organic or external, these days. ;)
-
Day 30: Cutting open a packet of new filters. The Bigfoot Classic turned into the surprise most used knife for me on this Challenge.

-
DAY 30
Pocket Rocket Challenge Completed!

-
DAY 30!!! This pic says it all

Used the MiniChamp to open a bandaid (see 111 Wednesday for full details).

Overall, I came to appreciate 58mm more than before. The screwdriver equipped models are my favorites, because it works well. Scissors are OK, but not as much leverage as I'd like on plastic like trimmer string or wire ties. Great challenge! Congrats to my comrades, and I hope to eat some to the tasty looking food you make someday! (Not as sure about drinking tea)
-
@Fireman said:
DAY 30!!! This pic says it allOverall, I came to appreciate 58mm more than before.
This is what I was the most curious about; if people would have an increased appreciation of the teeny SAK's?
I know that pre-1995, I had the idea that the littlest SAK's were a joke. A kind of toy for the three piece suit crown that needed to address a chipped nail before a meeting of the board. But my better half showed me how wrong I was. Since then, I had used, and relied on a classic when there was nothing else available, like on vacation in Key West where I had mailed a classic to myself where we were staying. No, they won't carve a steamship round of beef, or do bushcraft things like make a log cabin. But for the mundane everyday little job of life, they do very well. And they actually didn't self destruct under my wife's very marked abuse! :o
-
@cbl51 said:
This is what I was the most curious about; if people would have an increased appreciation of the teeny SAK's?I know that pre-1995, I had the idea that the littlest SAK's were a joke. A kind of toy for the three piece suit crown that needed to address a chipped nail before a meeting of the board. But my better half showed me how wrong I was. Since then, I had used, and relied on a classic when there was nothing else available, like on vacation in Key West where I had mailed a classic to myself where we were staying. No, they won't carve a steamship round of beef, or do bushcraft things like make a log cabin. But for the mundane everyday little job of life, they do very well. And they actually didn't self destruct under my wife's very marked abuse! :o
Perfectly stated.I think it is funny that for the past 30-days Mrs Nix (not a knife person) has been EDCing a bigger knife (her Dragonfly) than I have (Esquire). I try to get her to appreciate the Classic, but she won't have anything to do with a knife without a lock. She values the safety aspect of locks and doesn't trust anything the can spontaneously fold up onto your fingers. Like I said, she's not a knife person.

-
<u>Day 30</u>


Rambler attended coffee and lunch duty, the blade has been getting a little gunky lately and it's time to give it some TLC much needed.
First off, gonna** thank Barry for hosting this great challenge**.
After doing a lot of heavy weight challenges earlier this year, this surely is a fresh breathe of air. So very different from the 91mm format that I'm accustomed to.I have decided to stick with my Rambler for the entire month and am a little more than surprised how well the small phillips worked, especially for toys or kids related stuff. The scissors cut kinda slow and it took me a good while to get used to it--eventually, I figured out the best way to open food packages is simply keeping the scissors open and 'slide' it right thru(instead of doing the scissoring motion).
The blade use needed some getting used to. The back spring on the 58mm is pretty soft(rightly so), and I always have this healthy fear the blade would close onto my finger if I am not paying extra attention. So for the entire month, it's kinda like a refreshment course for my own knife safety rules. Every knife use was deliberate and cautious.
And last but by no mean least, gonna thank all of you whom have participated in the challenge, I have always learnt something from all these wonderful postings and felt I get to know each of you a little bit better. That's golden!

-
Day 30
Challenge complete!!
Well done all…Final calculator pics. 2xHP42, the clone and IPhone app (emulator). Progress

-
Nice final pic Appleandrew! Was fun posting the calculators, but I'm now all out of ones to post!
Day 30
Challenge complete, and also our roadtrip. Got back today after 4 days in the mountains near Lesotho.
I really enjoyed carrying the Orange Alox and found I could get probably 80% of what I needed done with this little SAK, and there will be times I'll carry it again, but I think I'll stay with my 91mm options for most of my daily needs.


-
@SteveP said:
I didn't even realize how dull the main blade had become on my Mini Champ until I started using it more during this challenge. But I've had it for over 20 years and have never sharpened it.I'm a complete newbie at sharpening knives, but the Victorinox dual knife sharpener put a nice edge back on it (and on the small blade on an Explorer). I don't have the experience to say if it (or I) did a really good job, but it's sharper now so that's improvement!
Anyone with more experience got an opinion on this sharpener?
I think many good advices have been given, and to quickly sum it up--I personally would rate the pull thru sharpener as the lowest, since it does pull away a far amount of metal and I only would reserve that for trashy knives that I don't care and if I don't have anything else to repair/sharpen the knife with.
Free hand sharpening stone is king, without a doubt. Given enough practice and skill, you could virtually sharpening any sharps you want. I tend to use free hand sharpening stone only for those knives that I love and needs extra attention.
For most other knives, so as long the sharpening angle is between 15-20 deg per side, I would try to use my Spyderco Sharpmaker. It really is the best compromise between money spent, practice time and result. Unlike free hand shaprening which you need constantly a fair amount of practice to yield good result, with just the minimum practice, you could get pretty stunning result from Sharpmaker. The only complain I have about this unit is even with CBN/diamond rods, the unit is meant to "keep sharp", especially on harder steel like S30V or S90V. If the edge on a supersteel is too dull, it will take a looong time to get it sharp on the sharpmaker.
@ElevenBlade said:
When you're as clumsy as me, would you be able to keep the angle steady? Do you just need to keep the blade perpendicular to the base? Is there an advantage to using this over a set of stones? (I'm guessing the answer is yes, and that it's actually easier to maintain a consistent angle) Can it get as sharp as 8000-10,000 grit stones? Am I asking too many questions?
Long sharpening session will fatigue anyone, and hard to keep the angle constant. But as stated above, I do think Sharpmaker is probably the best compromise there is.
Keep the blade perpendicular to base at all time, yes. But it is a common misconception and mistake to hold the handle level while doing the sharpening.(Yes, even Sal gets it wrong on his instructional video) If the knife you are sharpening is not a wharncliffe, then as you approach the upswept of the blade on the rods, you should always lift the end of the handle up respectively, so the tiny segment of the blade touching the rod is always perpendicular to the rods. That is the only way to keep the bevel even and consistent from body to tip, otherwise, the bevel would widen a lot at the tip if you are not careful.
The same logic would apply to sharpening on a motorized belt(such as work sharp).
The earlier infomercial/advertising was pretty poorly done and quite misleading, as if you could just pull the knife straight thru and you are done:
https://youtu.be/_3dngV4nhJk?t=46They must have received a healthy amount of (angry) inquires about ruined bevel, and instructional 2 years later is a lot more accurate:
https://youtu.be/JKXCatb35ew?t=103 -
Day 30
Final analysis...
Ive been looking forward to this challenge for quite some time. The Classic is a .... well... classic. So many people out there carry this as their one and only, and it does the job.
On the outset, there are a few distinct advantages to this knife for me.
- it's extremely light
- it blends in to an office environment
- all tools open like a slipjoint instead of a "butterfly"
- it has 3 tools I want in an EDC, and is about the lightest pair of scissors around.
However, there is just one drawback.
- I feel like the blade could be a teensy bit deeper. I've never felt the blade on the LM Micra to be too small, as an example...
- when it comes to impromptu food prep, I have to give it to a medium sized SAK... The Classic just doesn't cut it.
I thought about the Ambassador, but I'd have to modify the file to an SD, and I'd just rather not, when I have other options.
So combining the several positives and the negative I'll say for the next long while, the Classic will accompany me at work for package opening duties.
The Classic alone really hasn't been burdensome, so I'll probably carry it for the next few days until I'll need something else for the weekend with outdoor cooking on schedule.

-
@Nix said:
I think I got my Sharpmaker when the band R.E.M. was topping the charts and quiche was still popular. My base is just a chunk of plastic with holes in it. The underside is flat...sort of. Sal Glesser probably made it himself...in his garage...I think it came with some brass rods that served as a guard....not sure where those went.

Still works, though. :D
Quiche isn't popular?

-
Excellent work, everyone! The calculator theme was an added bonus!
Thanks to Barry for getting the ball rolling!
Day 30 bonus
Time for a celebratory beer, with the Midnite Minichamp doing the opening honours. And a pic of all my pocket rockets together with a Wenger watch case opener branded for Omega and a Victorinox baker’s knife branded for Alipro to add some blue and green Alox loveliness!


-
Day 30
Kudos to Barry for suggesting this challenge. It’s been fun to shake things up a little. However, I was pleasantly surprised to find myself brought all the way back round to where I started with 58s - the Midnite Manager (in blue). Everything a multi tool lightweight like me could possibly need. Now don’t panic - I’m not about to trade in all my other SAKs. But I am looking forward to pairing my Blue Pioneer (or Cadet, or Yeoman or …) with this little beauty.
All the best y’awl.

-
:ahhh Day 30 :ahhh

Well here we are, the end of the line. It's been a fun month - I've only done a small number of challenges in my short time here, but this has probably been the most enjoyable just for seeing the inventive ways people have been able to use the smaller SAKs.
As a mainly urban office dweller who needs to be wary about what he carries where, the 58mm line is definitely one I can get away with having on me and the Classic and Mini Champ have certainly come in handy for the majority of things I've needed to do. I've certainly come to appreciate them more and I'm now going to have to remember to take the Classic off my keyring next time I go abroad or to somewhere I'm likely to be searched.

-
Final day

Congrats on finishing the challenge y’all!

-
Day 30.
I've really enjoyed this challenge and it's been a great chance to see what a huge range of things you can achieve with such a small knife. The Classics are almost endlessly fun and carryable. Whilst they might not cut it (forgive me) as your ideal kitchen knife let's be honest that at 58mm that's a heck of an ask.
The Executive is a fairly good sweet spot and has an excellent file so it always wins out for me over the Ambassador. If only Vic would bring out a Delemont PTC.
Today has been a quiet day for my Mountains are Calling Classic (and that could be the Drakensberg Max - I did go up the Sani pass many years ago from Natal and have been to a few camps in the 'Berg) and here we are on my team HTC cycling jersey. I'm a Mark Cavendish fan


-
@Fast Bill said:
Day 30.
. I'm a Mark Cavendish fan
Great to see him win yesterday’s stage! When I started racing back in the late 70s British heroes on the road were Robert Millar, Sean Yates and Malcolm Elliott - all of whom soundly beat me at RTTC and BCF events before they moved overseas to pursue cycling careers and I went there to study and then work!

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login