EDC Skelesurge :-)
-
I just noticed, that the freestyle weight exaclty the same even though it doesn´t have scissors or the bitholder :-D
-
Looking to be a brilliant mod. Love it! :D
-
:o that looks really cool

-
Result mate

-
Getting better & better... :D Great Mod, Shorty...

-
Excellent mod, could you post the step by step picture of the scissor transplant?

-
:ahhh That is just plain cool :o :D :D :D Can't wait to see what else you are gonna do

-
Wow, this is awesome. Great job there

One of the reasons why my EDC has changed from a Skeletool to a Spirit is because of scissor. I wish Leatherman had thought of this >:( -
They do look like they fit great. Awesome work.

-
:o That's great man! I'm surprised that is fits so nice. So, what's next?
-
GREAT! :-O
-
@duckman1975 said:
Excellent mod, could you post the step by step picture of the scissor transplant?
I didn´t take any picuters of the actual transplant, im afraid. I will have to take the skeletool apart again when the T-shank holder arrives though. If that is early enough to you (i expect shipment in a few days) i could take some pictures of the scissor mounting, too.
Next will be the t-shank holder... sadly the lasercutting company is awfully slow :-(
-
At least you've found a company who'll do small orders of cutting. I need that :-\
-
Excellent mod, could you post the step by step picture of the scissor transplant?

I didn´t take any picuters of the actual transplant, im afraid. I will have to take the skeletool apart again when the T-shank holder arrives though. If that is early enough to you (i expect shipment in a few days) i could take some pictures of the scissor mounting, too.
Next will be the t-shank holder... sadly the lasercutting company is awfully slow :-(
Thanks man

-
hey shorty66, could you go into detail what you had to do to the bit holder layer to make the scissors fit? A drawing or pix would be great. Sounds like a good mod to do to the new freestyle.
-
Looks good Shorty

-
That's a great mod.

-
The bitholder layer is completely uncompromised by the scissors.
The scissors just replace the bit storage compartment. Its quite easy:
Open up the screw on that side, lift the storage compartment material over the remaining screw axle and turn it to the side.
Then cut it near the end so that just a little bit is left to assure the layer remains at its initial width.
The scissors fit perfectly over the screw axle. You just have to reduce their width a bit to make sure you are able to close them.
Than just slide the upper layer back over the screw and screw it all tight.I will post some pictures when i am taking the tool apart again.
Sadly the lasercutting company seems to have lost interest in making money with me. Perhaps i will have to make the part by hand... -
thanks. I just could not quite tell from the pix. this would be good on a freestyle, then all i would need was a multibit screwdriver.
-
If you didnt purchase your freestyle yet i`d rather buy a skeletool and cut of the biner like i did. Adding the bitholder to the freestyle will be a lot more complicated than adding scissors...
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login